1995 Z-28 Camaro on 2040-cars

VIN: 2G1FP22P4S2188673 Year: 1995
Make: Chevrolet
Model: Camaro
Warranty: Vehicle does NOT have an existing warranty
Trim: Z28 Coupe 2-Door t-tops
Options: CD Player
Drive Type: 4 l 60 e has been gone through
Safety Features: Anti-Lock Brakes, Driver Airbag, Passenger Airbag
Mileage: 99,767
Power Options: Air Conditioning, Cruise Control, Power Locks, Power Windows, Power Seats
Exterior Color: Teal
Interior Color: Gray
Number of Cylinders: 8

Condition: Used: A vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections. ... 

 Not for the Faint of Heart!!  This car is absolutely stupid!!!  And stealthy!!  Car sat for a year before I disided what to do with it. 3rd and 4th clutches were out of it and needed fixed. After doing some very long research it was time to go for it. I replaced just about everything feeeeezable that needed to be replaced!  Hughes, Trans-Tec, and Sonnax servos and an upgraded Sunshell, along with a Derale trans cooler. Torq converter is from a Buick V-6! Fins have been furnaced brazed by a local trans shop with a stall of around 26-2800.  (I think you get the idea) Ok; Now whats in front of this is a 383ci. aluminum headed small block Lt-1. I was told by the previous owner that it had Lingenfelter upgrades done to it, but after calling Lingenfelter and talking to them, they told me where to look for there ID in 2 places. One place I couldn't see (poor eye site) and the other had none. The camshaft was a blank core that they (LPE) had ground with there profile (see timing card in pictures). So unless I pull the engine to see if there is another stamp (which isn't going to happen!) it'll just be a mystery! Recently; during this past summer I was cruising to Indiana and broke a valve spring!!! Lucky it wasn't those beehive springs. So I ordered a kit, and they are new as are the new Crane roller rockers 1.5s  It had 1.6s in it but I had a new set laying around so I put those in. The throttle body is a BBK (58mm) with a cold air induction tube, The shorty headers are BBK as well.  Injectors are 30lbs Accel's Fuel pump has been changed also, with Flowmaster exhaust front to back. And and chip stage 2 from Jet.  The only thing that this car needs is to have the shift points changed or set, 1.6 rockers (if you want to race it!) and the guts to push it past 140mph! Yes there is some wear driver seat has a little wear to it, the upper dash is cracked, (typical) the console hinge is broke also. The paint is fair needs a few touch up places, I'll show those in the pictures. Just little things that's all. The car sets in a heated garage, I don't really drive it to much, maybe on a nice night.   Questions???   Thanks for Looking.  I'll try and add more pictures or if you need more picture send me a message here.

---

On Feb-10-13 at 11:28:39 PST, seller added the following information:

Just wanted to add that I do have the right to remove this ad at any time as I do have it forsale locally.  Also thanks to all those who have either came by to personally look at the car and to those whom have asked questions and wanting more pictures.   Thanks again