2005 Ford Excursion Eddie Bauer Sport Utility 4-door 6.0l Lifted on 2040-cars

Auto blog

Ring Brothers shows 1965-66 Mustang fastback carbon fiber body

We covered one of Ring Brothers' more extreme SEMA builds yesterday, the De Tomaso Pantera-based ADRNLN, but if that well-executed but over-the-top Italian-American exotic is too much for you, then perhaps this Ring Brothers 1965 Ford Mustang fastback with a carbon-fiber body suits your tastes better.
What the performance-parts manufacturer is showcasing with the Mustang is the carbon-fiber body itself, which is fashioned around the 1965-66 fastback. It can be bought from the company and bonded to the skin and unibody as a do-it-yourself project, or you can take your Mustang to Ring Brothers and have the body installed there. The fenders, doors and quarter panels are two-inches wider than stock, and Ring Brothers offers a custom widebody chassis to those who want the complete package.
The show car looks sharp in person lowered on HRE wheels, and we appreciate the bare front end so we can see the supercharged V8 and front coilover suspension, though the details on those performance upgrades are slim. Also note the custom independent rear suspension setup at the rear.

Ford demonstrates Mustang's new Line Lock burnout feature

Been saving your pennies for a 2015 Ford Mustang? Put in a few extra shifts or some overtime? Got a great down payment ready? Well, however much you saved for your new pony car, start saving more - you'll need the extra money to spend on tires.
That's because the Mustang will come with a system called Line Lock, which can lock the front brakes electronically, allowing drivers to perform big, dumb, smoky burnouts without moving so much as an inch. It's sort of like launch control, only the average driver might actually use it.
Now, line locks aren't uncommon, particularly in drag racing. Usually, a flip of the switch locks the front brakes. The Mustang, besides offering the system from the factory which is unique in and of itself, looks a bit more involved.

Ford, GM to collaborate on 9- and 10-speed transmissions

Back in October, there were reports that General Motors and Ford Motor Company were hard at work co-developing new nine- and ten-speed automatic transmissions, and now both automakers have confirmed this joint operation. While there are no specific vehicles mentioned to receive either transmission, a collaborative press release issued by GM and Ford mention that the transmission will be designed for front- and rear-wheel-drive cars, crossovers, trucks and SUVs.
These aren't the first powertrain components developed jointly between these cross-town rivals, either. The six-speed automatic currently used in vehicles like the Ford Edge, Ford Fusion, Chevrolet Cruze and Chevrolet Equinox was engineered in a similar fashion. As is the case with this existing transmission, both automakers will assist in the design, development and testing of the new transmissions, but each will build its own units in its own factories. Scroll down for the official press release.