2006 Dodge Grand Caravan Se Braunability Wheel Chair Handicap Van! on 2040-cars

Auto blog

Chrysler to accelerate production of 2013 Ram and V6 engines

Chrysler is adding a third shift at its Warren Truck plant to meet demand for the new 2013 Ram pickup. And with tight supplies of its Pentastar V6, the company is also boosting output at its Mack Engine plant.
The expansions will add 1,250 jobs and are part of a $238 million investment by Chrysler in the Detroit area. Warren's third shift will begin work sometime in the spring, a Chrysler rep told Automotive News. Mack's increased Pentastar production a could include both 3.6 and 3.2-liter engines.
The company says it also plans to invest $40 million in its Trenton Engine plant to allow for production of a 3.2-liter V6 as well as the Tigershark inline-four for the upcoming Jeep Liberty replacement.

Dodge vs. Chevy tug-of-war taken to the extreme

They say "idle hands are the devil's playground," but said playgrounds grow to Disney-sized proportions when a pair of jacked-up trucks, two egos, a chain and an empty mall parking lot are involved. Proof of this is the video below, which shows a Cummins-powered Dodge Ram circa 2006 to 2008 chained tail-to-tail with what looks to be a gasoline-powered Chevrolet Silverado from the late 1990s or early 2000s.
We don't necessarily have to tell you who wins this battle, but we'll let you see for yourself the lengths the "winning" driver goes to prove his point. There's plenty of foul language in the video below, so beware that this might be Not Safe For Work, and not that we should have to tell you, but please, do not try this at home.

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.