1997 Acura Integra Type R Sleeved B18c1, 233whp, 4.9fd Have Stock Block + Parts on 2040-cars
Redwood City, California, United States
|
Cliff Notes: Car currently has a built B18C1 sleeved 2.0L engine in it now. I have a the stock numbers matching block that's refreshed that will be included with factory parts of auction exceeds $11,000. Otherwise only the built engine is included. *I purchased the car from a honda-tech member in NOV of 2012 and have owned it in CA where it currently resides. Car currently has about 101K miles on it. I've taken it to about 6 trackdays and the previous owner took it to about 12. 1997 Integra Type-R #0110 Clean WA state title (never registered in CA) The good: Clean Title Straight body No major damage Well maintained Comes with lots of extras, including rebuilt VIN matching B18C5 block if auction exceeds $11K The bad: Very small/minor scuffs on exterior Front lip has a big crack in it, together now with a brace and ductape Front bumper, hood & fenders replaced by previous owner after front-end collision (OEM parts) The starter solenoid has begun to act up. Will need a new solenoid at some point. I have to tap the starter every 50 starts to get it going. Car will need a 4 wheel alignment, it's a bit off after putting stock suspension back on Story: This is a well maintained 1997 Integra Type-R with a number of modifications, but also included (if auction reaches $11K are a majority of the OE parts required to return the car to near-stock. #0110 was purchased from the original owner in 2003 100% stock minus the JDM 16 wheels and modified Koni shocks. #0110 was my daily driver until 2005 at which point she went under the knife for a 2.0L track-car build. #0110 attended ITR Expo-5 in Omaha Nebraska in 2005, and has been a garage queen and occasional weekend car since. #0110 has attended about a dozen HPDEs, and just about as many passes at the drag strip. I am selling #0110 because Im just not getting the enjoyment out of her that I used to. The engine build started in 2005. The 2.0L block now has about 25,000 miles, but despite its age the engine is still strong. I touched up the tune in early June 2012 and made 233whp and 159wtq on a DynoJet, which are the highest numbers yet. Before the dyno compression was 230/250/250/240, so the engine is healthy but starting to show its age. The oil is changed every few months (~500 miles) with Mobil1 5w30 Synthetic with OEM filter (15400-PLM-A01 Filtech). Valve adjustments are performed every-other oil change. The car still has the factory equipped Air Conditioning (charged) but needs a belt and idler pulley to operate. #0110 was re-sprayed inside/outside in 2002 with DuPont Championship White paint by previous owner after a front-end collision. All work was completed at a well-known body shop with all components removed before paint, including glass. Replacement parts were all OEM from a donor car, including bumper, hood and fenders. Included with the vehicle purchase are pictures of the donor car and full receipts of the work performed. Other than the missing VIN tags on the bumper/fenders/hood, you would never know this car was in an accident. Radiator support is intact. Exterior Condition: Make no mistake, this car has been tracked. Ive hit a few cones with the front bumper, and consequently there have been a slowly increasing number of scuffs and faint paint cracks forming on the front bumper. This damage is not noticeable from +10ft. There are a couple minor dings/chips, I know where they are and you probably wont see them unless you look hard. Other than that, there are no dents or damage to the car. Interior Condition: Carpets are a little worn, but still in good condition for the age of the car. Seats are in okay shape, not too much wear but two cig burns on the driver side. Car was not smoked in, but i purchased used seats from another ITR that has these burns. Original seats were sold prior when recaro seats were installed. #0110 has the original badge/armrest. Non-smoker no Pets. Bolt-Ons: Custom 3.5 Aluminum Intake w/3.5 > 6 Velocity Stack + K&N Filter Omni 70mm TB port matched to the stock ITR intake manifold Skunk2 MegaPower Header T1R Resonated Testpipe T1R 70R 70mm (2.75) catback exhaust. *Currently has an APEXI 70mm WS2 muffler to be slightly quieter, still have the T1R muffler. Shortblock *assembled in 2005 by Earl Laskey (RIP)*: 85mm B18C1 block with Benson sleeves, work performed by Dan Benson @ Benson Machine CP 12.0:1 forged pistons Eagle H-Beam connecting rods with ARP2000 bolts ACL rod & main bearings 87.2mm GSR Crankshaft micropolished and balanced by Dan Benson @ Benson Machine Baffled Oil Pan ARP Head Studs Stock motor mounts w/urethane inserts Cylinder Head: PR3 ITR head with 85mm chambers Deshrouded valve reliefs Custom valve grind 0.008 off surface Stock ITR ports Skunk2 Pro-series Stage 3 camshafts Skunk2 Pro-series Cam Gears SuperTech Valves (std. size) SuperTech Valvesprings SuperTech Titanium Retainers Cometic 85mm headgasket Greddy High-Strength Timing Belt Crankcase EVAC / Catch Can: Pulls vacuum (max -7 inhg) on the crankcase for improved ring seal and reduced blow-by through a slash-cut exhaust bung Custom 1800cc sealed catch-can made from 0.090 6061 Aluminum Two -10 AN w/Pro-Lite 350 lines to the back of the block (-10 AN fittings) One -10 AN to Barbed Fitting for line to exhaust slash-cut / EVAC One barbed fitting to valvecover One -6 AN w/Pro-Lite 350 line drainback to block Drivetrain: 97 ITR S80 Transmission w/OEM ITR LSD *matching VIN* ATS 4.929 Final Drive Exedy Stage-2 3puck lightweight sprung clutch Fidanza 7.5lb Flywheel New seals/bearings installed in January 2008 I recently at 100K Installed an aluminum radiator alpha skunk2 I recently at 100K also rebuilt the transmission as there was a grind. A new 3rd gear was purchased. Installed a GSR 5th gear, and brand new syncrotech carbon syncros for all gears. Suspension/Brakes: *100K Hawk HP Plus pads front and rear Brembo Blank rotors (front & rear) ATE SuperBlue brake fluid Groodrich SS brake lines Wheel/Tire: JDM ITR 16 wheels in championship white Falken 912s i think 215 series tires with lots of tread remaining. Electronics/Fuel: OBD2a-OBD1 jumper harness P72 ECU with eCtune (tuned by me, license will transfer to new owner) RDX 410cc injectors w/Xenocron adapters (plug-and-play connectors) Replaced Distributor in 2005 with engine build NGK Blue Plug Wires (installed 2005) New Distributor cap/rotor (2011) New NGK BKR7E Plugs every 5,000 miles OEM parts that come with car if auction exceeds $11K *OEM 1997 B18C5 ITR shortblock w/matching VIN* with new bearings, seals and water/oil pumps OEM 1997 ITR exhaust manifold OEM 1997 ITR Intake Arm & Resonator Box OEM 1997 ITR exhaust (catback) OEM 1997 ITR springs OEM 1997 P73 ITR ECU OEM 1997 ITR Throttle Body This car could be returned to mostly to stock. The cylinder head currently on the car has enlarged bores to match the 85mm block, therefore it cannot be installed on the rebuilt OEM 81mm shortblock. If the new owner wishes to install the OEM 81mm shortblock, a PR3 VTEC cylinder head will be needed. |
Acura Integra for Sale
1997 acura integra ls - v6 j32a2 swap - j-series swap vtec - with extra tl motor
98 acura integra red 2 door hatchback needs transmission(US $1,200.00)
1990 acura integra rs hatchback 3-door 1.8l(US $2,495.00)
1995 acura integra se auto 3dr repaint 2012 green with tan interior low reserve
Street runner for sale custom car 94 acura integra with f20b motor(US $5,000.00)
1997 acura integra gs-r hatchback b18c1 dohc vtec 5 speed manual white(US $2,950.00)
Auto Services in California
Zoe Design Inc ★★★★★
Zee`s Smog Test Only Station ★★★★★
World Class Collision Ctr ★★★★★
WOOPY`S Auto Parts ★★★★★
William Michael Automotive ★★★★★
Will Tiesiera Ford Inc ★★★★★
Auto blog
Acura claims MDX is best-selling luxury 3-row ever
Fri, 11 Jul 2014Business for Acura has been in a weird place, recently, and the company's latest car launches have been especially rocky. For example, the ILX Hybrid was recently discontinued after just two model years with only about 2,660 sold in that time. The company also delayed the launch of its new TLX by a few months until later this summer. However, despite its issues with sedans, the automaker's utility-vehicle business in absolutely booming. In fact, it now claims that the MDX is the best-selling three-row, luxury SUV, ever.
The MDX is already leading its class this year with 30,664 units sold through June 2014, up 68.4 percent compared 2013. Also, in five of the last six months of reported sales, Acura has posted gains. It appears that the company's utility lineup is really pushing it along.
To take the bestseller ever crown, Acura claims that through its three generations, the MDX has sold a cumulative 692,710 units. The premium model has also been at the top of the annual sales rankings for three-row luxury crossovers every year since 2002. The company believes that its nearest competitor is the Lincoln Navigator with an estimated 420,000 lifetime sales, and even arguably more comparable vehicles like the BMW X5 and Mercedes-Benz M-Class only have 350,000 or fewer sales under their belts. Of course, it probably doesn't hurt that the MDX has one of the lower starting prices in its class.
2014 Acura RLX gets trick hybrid all-wheel drive system for LA
Tue, 19 Nov 2013Acura has endured a year of mixed reviews and middling sales for its new RLX flagship. Meanwhile, the Japanese automaker has been readying what may be the very best version of the car for its debut. Now the wait is almost over, as Acura will show its 2014 RLX Sport Hybrid SH-AWD at this year's LA Auto Show.
When it comes to dealerships in the spring of 2014, the RLX Hybrid will be the most powerful production car Acura has ever sold. The combination of a 3.5-liter V6 and three electric motors - a 35-kilowatt motor pushing torque to the front wheels and two 27-kW units feeding the rears - creates a total system output of 377 horsepower.
Those rear-end electric motors do more than just add power, they also drive the rear wheels without a traditional rear drive shaft and differential. This newest iteration of the Super Handling-All Wheel Drive calls upon the two rear motors to both drive and brake the rear wheels, vectoring torque in cornering situations for additional grip. All three electric motors make use of regenerative braking to feed electricity back into the system's 260-volt lithium-ion battery pack.
Ludacris discusses Fast and Furious 7 and his 1993 Acura Legend
Tue, 13 May 2014It's easy to think of most wealthy celebrities as egotistical, materialistic individuals who own a Ferrari for every day of the week. The reality, though, is often much less severe. See, they can get attached to things, like cars, just like normal folks. Take Alfred Morris, for example. A 22-year-old running back with the Washington Redskins. Morris still drives the 1991 Mazda 626 that he had in college, despite a healthy $2.2 million contract.
Rapper/actor Ludacris is an even more extreme example of automotive loyalty. With an estimated net worth of over $70 million, Luda has the money for his own private plane. Yet that wealth doesn't stop him from regularly driving the 1993 Acura Legend he has had since before he found fame.
Ludacris, whose real name is Chris Bridges, recently discussed his old Acura during an appearance on the Ellen DeGeneris Show to promote his new album. It sounds like he's put 10,000 miles on the trusty sedan since it last popped up online less than a year ago, so it's pretty clear that he drives it on the regular. In fact, Ludacris says he still pens new songs sitting inside it, just like he used to back in the day when he was starting out.