2011 Ford Fusion Se Sunroof Leather Sync Spoiler 58k Mi Texas Direct Auto on 2040-cars

Auto blog

Ford and Chrysler reducing summer plant shutdowns

Most domestic automaker assembly plants traditionally take a couple of weeks off during the summer. The shutdowns give each plant time for much needed repairs and maintenance, and in some cases, help better align production with demand. Not this year, though, as demand for many models is outstripping what Ford, Chrysler and General Motors plants can produce.
Ford has announced that it will shorten its annual summer shutdown for most North American plants from two weeks to one. The shorter shutdown will increase the carmaker's annual North American production by 40,000 units on top of the 200,000 extra units that it was already planning to produce this year versus last. Automotive News reports that Ford produced 2.8 million vehicles on this continent in 2012, and that output this year has already increased 13 percent through April.
Chrysler, meanwhile, is also operating at full tilt and plans to run some plants through the summer with no shutdown at all. Those not getting a break include Jefferson North where the Jeep Grand Cherokee and Dodge Durango are assembled, Toledo North that will assemble the new Cherokee, and Conner Avenue, home of SRT Viper production. Other assembly plants will be down for a single week, while all of Chrysler's engine and transmission plants except one in Indiana will continue operating with no shutdown this summer.

NHTSA and Ford investigating steering issues in Crown Vic, Grand Marquis and Marauder

There may be more steering woes for the Ford Crown Victoria. The National Highway Traffic Safety Administration has opened a preliminary evaluation into the Crown Vic and Mercury Grand Marquis from the 2004 to 2007 model years and the Mercury Marauder for the 2004 and 2005 model years because the steering shaft can jam. The issue could potentially affect an estimated 500,000 vehicles.
According to the regulator, there is a possibility that the driver's side heat shield for the exhaust manifold can rust, dislodge, and then wedge into the steering shaft. If this occurs, it leads to a situation where the driver can no longer control the car.
NHTSA has received five complaints of this happening, including one alleged case with an injury. In that situation, the car was driving onto the highway, lost control and rolled over. One occupant was hurt in the accident.

2015 Ford Mustang EcoBoost flogged and analyzed by Ignition

Aside from the way it looks and perhaps its independent rear suspension, the biggest bit of news on the 2015 Mustang may be the inclusion of its 2.3-liter, turbocharged four-cylinder engine. That blown mill marks the first time since the Mustang SVO of the '80s that a turbo has been fitted under the engine of Ford's pony car.
The Mustang EcoBoost is the subject of the latest episode of Ignition from Motor Trend, giving us a great look at the technical, nitty-gritty side of the turbocharged coupe. Covering it from bow to stern, host Carlos Lago walks us through the boosted Ford before taking to the track for some driving impressions, with particular praise given to the low-end grunt of the 2.3-liter mill.
Check out the full video and then let us know which 2015 Mustang has your interest piqued the most - the EcoBoost four, the 5.0L V8 or the entry-level V6.