2014 Ram 3500 Slt on 2040-cars

Auto blog

2014 Ram Promaster recalled over stuck pedal fears

Ram's new, Fiat-derived cargo van, the ProMaster, is set to be recalled over concerns that the accelerator pedals could stick. The issue affects 9,655 ProMasters, with 7,935 vans in the US, 1,437 vehicles in Canada and 283 in Mexico.
There have been no reported injuries or crashes from the issue - according to The Detroit News, there haven't even been any customer complaints. The issue was reportedly discovered while Chrysler was testing the vehicle at its proving ground, which is what prompted the internal investigation. Still, it's unlikely that ProMaster vans will suffer from unintended acceleration issues, as each van is equipped with a brake-throttle override.
As of this writing, there's been no bulletin or activity from the National Highway Traffic Safety Administration.

Ram CEO rules out Hellcat pickup for now [w/poll]

If you've been waiting for Chrysler to shoehorn its new Hellcat engine into the Ram 1500 pickup, you may be waiting a while. Our compatriots at Car and Driver spoke to Ram CEO Bob Hegbloom about the prospect of a Hellcat pickup, and his answer was less than promising: "At this time, I would say no."
That doesn't mean it'll never happen, but does suggest that such a project is not currently in the cards. Which is a bit of a shame, considering how the last Mopar muscle truck turned out. The Dodge Ram SRT-10 was powered by essentially the same V10 engine as the Viper, channeled (in the short-cab version anyway) to the rear wheels through a six-speed manual. The supercharged, 707-horsepower Hellcat engine now available in the Challenger coupe and Charger sedan is even more powerful, and would make one heck of a performance truck - the kind that, long-travel suspension aside, might make some enthusiasts forget all about the Ford F-150 SVT Raptor.
In the meantime, we're still holding out hope that the Trackhawk name registered by Chrysler recently will point the way towards a Hellcat-powered Jeep Grand Cherokee SRT. Where would you most like to see the Hellcat engine pop up next?

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.