2014 Ram 3500 Longhorn on 2040-cars

Auto blog

Ram bringing Rumble Bee Concept to Woodward

The 2013 Woodward Dream Cruise is taking place this weekend, and will see the arrival of over 1.5 million people and around 40,000 vehicles of seemingly every make in history. It's also a huge event for the manufacturers that call Detroit home, with Chevrolet setting up shop in Birmingham, Ford and its Mustang Alley locating itself in Ferndale and Chrysler hunkering down at 13 Mile in Royal Oak.
Ram will take advantage of the captive audience (if you think we're joking with the use of the term "captive," you've never tried to get off of Woodward during The Cruise) to show a new concept truck. And, judging from these teasers, it's going to be.. the Rumble Bee. In the past, Ram offered a Rumble Bee edition Ram 1500 that was mainly a styling treatment, but they were kinda cool trucks for those that wanted a muscle car but needed the room and utility of a big vehicle.
Details on the new Rumble Bee are scarce, but judging by the images seen here, it will sport bright yellow paint and a pair of large, black, five-spoke wheels wrapped in low-profile tires. The hood sports a set of hoodscoops for a bit more aggression, while the interior gets a reinterpreted dial shifter for the eight-speed automatic. We also see what may be a button to let a bit more rumble emanate from what we'd assume is a large Hemi engine underhood. Take a look at the gallery below to see both teaser images, and check back here for more as soon as we get it.

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Chrysler banks $507 million in Q2, trims 2013 earnings forecast

Chrysler has some good news and some bad news. First, profits were up 16 percent over the second quarter of 2012, bringing the Auburn Hills, Michigan-based manufacturer $507 million on the back of strong demand for trucks and SUVs (a recurring theme this quarter, particularly in the US). Q2 revenue was up as well, from $16.8 billion in 2012 to $18 billion in 2013. The bad news is that the Pentastar's overall earnings forecast for net income in 2013 has been trimmed from $2.2 billion to between $1.7 and $2.2 billion, according to Automotive News.
In addition to the adjusted net income forecast, Chrysler tweaked its operating profit from $3.8 billion to between $3.3 and $3.8 billion. This has gone largely unexplained by Chrysler, perhaps hoping the news of a three-percent increase in its transaction prices for Q2 will allow it to sweep this adjustment under the rug.
The star of the show for Chrysler has been its US sales, which saw a 10-percent jump, both bettering the industry average of eight percent and improving over the same stretch of 2012. As with the increase in transaction prices, Chrysler has the new Ram pickup and Jeep Grand Cherokee to thank. Perhaps most worrying from this report, though, is that every brand in the automaker's stable saw an increase in sales... except for the Chrysler brand itself.