2011 Ram 1500 on 2040-cars

Auto blog

NHTSA investigating power modules on Chrysler Group SUVs and minivans

The Center for Auto Safety is officially petitioning the National Highway Traffic Safety Administration to begin scrutinizing alleged problems with the totally integrated power module (TIPM) on about 24 Chrysler Group SUVs and minivans. The advocacy group claims that the part's failure can cause affected vehicles to stall or not start at all. NHTSA is still looking into the accusations and deciding whether a full investigation is actually warranted.
The CAS petition claims at least 70 TIPM failures, but according to NHTSA, six of the complaints are for models that don't have the modules. In 34 of the reported cases, the vehicles refused to start, and in 17 of them the engine stalled. There were also two allegations of smoke and one of a fire. However, none of these affected airbag deployment or resulted in a crash.
This petition isn't the first TIPM-related problem for Chrysler Group. A recent report in the New York Times alleged that it found 240 complaints potentially related to the issue on NHTSA's website alone. In September, the automaker also recalled 230,760 examples worldwide (188,723 in the US) of the 2011 Jeep Grand Cherokee and Dodge Durango replace the fuel pump relay circuit inside of the TIPM-7 with one external to the unit. The original part could allegedly cause the models to stall without warning. Even earlier, the company also recalled about 80,000 examples of the Jeep Wrangler and Dodge Nitro in 2007 to have the module reprogrammed.

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Ram ProMaster City getting facelift courtesy of Fiat Doblo?

Our intrepid spy photographers have caught prototypes for a new Fiat Doblo. Now we know what you might be thinking (particularly if you didn't take note of the headline): why would we care about an automaker conducting a facelift on a European cargo van? Normally we wouldn't, only the Fiat Doblo has another name, under which it will be shortly be sold here in America: Ram ProMaster City.
Announced just months ago, the ProMaster City is the smaller counterpart to the Ram ProMaster, which itself is also a rebadged cargo van from Fiat Professional. Think of it as a Chrysler version of the Ford Transit and Transit Connect lineup - European vans being brought Stateside by automakers that operate on both sides of the Atlantic.
But despite the official announcement of the vehicle's pending arrival, we still haven't seen the PMC yet. The disguised Doblo prototypes pictured here appear to be wearing a completely new front end and some cosmetic revisions to their tail ends, too. We can't see anything in the interior, but the fact that it was completely covered up suggests that Fiat is working on overhauling that, as well.