2008 Mitsubishi Lancer Gts Sedan 4-door 2.0l on 2040-cars

Auto blog

Mitsubishi ASX is French for Outlander Sport

Mitsubishi has revealed the Euro-version of the same Outlander Sport model that debuted with updates earlier this year at the New York Auto Show. No, the French do not call it the Royale Sport (with cheese), but rather the ASX.
The crossover has received a range of aesthetic and engineering tweaks, including revised interior fabrics. Designers have also abandoned the old rotary knob switch for the vehicle's all-wheel-control system in favor of a pushbutton interface, though the largest change to the recipe comes in the form of a reworked multi-link rear suspension. Powertrain options remain unchanged, however, with a total of three engine mills on deck, including a 1.6-liter gasoline engine with 115 horsepower mated to a five-speed manual transmission in two-wheel drive configuration.
Those hunting up a little more traction can step up to a 1.8-liter diesel with 147 horsepower and 221 pound-feet of torque paired with a six-speed manual and the buyer's choice of either a two-wheel-drive or four-wheel-drive system. A low-CO2 1.8 diesel is also available with 114 horsepower. You can check out the full press release below for more information.

Mitsubishi recalling 166k cars, crossovers over stall risk

Mitsubishi is recalling 165,923 vehicles in the US because it's possible for the drive belt to detach from their engines, potentially causing a stall. Specifically, the campaign covers 2008-2011 model-year examples of the Lancer, Lancer Evolution (pictured above) and Outlander as well as the 2009-2011 Lancer Sportback and 2011 Outlander Sport. All of the affected models use some version of the brand's 4B1 four-cylinder engine.
According to the National Highway Traffic Safety Administration, the engine pulley can wear causing the drive belt to slip off. If this happens, the alternator, cooling fan and hydraulic power steering can all stop working, and obviously, any of those things could make driving unsafe. However, if the belt detaches, then a warning light should come on in the cabin.
To fix the problem, Mitsubishi dealers will replace the original belt with a redesigned rubber part and will inspect the pulley. If worn, it'll also be replaced free of charge.

Mitsubishi recalling i-MiEV models for brake problem

Mitsubishi is issuing a recall for the 2010-2014 i-MiEV that affects 1,810 units of the little electric car, because it's possible for the brake vacuum pump to stop working. If this happens, the result would be longer stopping distances, according to the company. The affected models were built between September 15, 2009, and March 25, 2014.
While this is just a single recall, there are actually two things that can cause this brake problem on the i-MiEV, according to Mitsubishi's filing with the National Highway Traffic Safety Administration. First, bad programming in the EV-ECU could cause the system to "falsely judge that the relay contact point is stuck," according to the full NHTSA defect notice PDF. Second, the vacuum pump exhaust hole could be corroded and blocked due to being splashed with road salt. However, the company says that if either fault happens, the brake warning lamp would illuminate, and there would be an audible alarm.
Depending on which issue is affecting an owner's i-MiEV, Mitsubishi is going to reprogram the software, replace the pump or both. Scroll down to read the recall report from NHTSA.