64 K! Gs 4.6l 224 Horsepower 4 Doors 4-wheel Abs Brakes 4.6 Liter V8 Sohc Engine on 2040-cars

Auto blog

Curtain officially comes down on Mercury as dealers remove signage

The process of shutting down the Mercury is complete. Ford officially made the decision to close its mid-level brand in June of 2010. In the months that followed, Ford offered its dealers money to stop selling the cars, with production shutting down in September. The last Mercury, a Mariner, rolled off the assembly line in the beginning of October and former spokesperson Jill Wagner said her good-byes to both the car and her job. Now the last piece of the brand has come down as dealers are removing any and all Mercury signage from their lots.
[Source: Detroit News]Read | Permalink | Email this | Comments

Translogic drives wood-burning Mercury Beaver XR-7

You read the title right, we're talking about the Mercury Beaver XR-7. No, Mercury never officially built a car called the beaver. This is the brainchild of upstate New Yorker Chip Beam, who owns and operates Beaver Energy, LLC. It runs on gases created by wood pellets fermented in a 2,400-degree furnace and fed to a supercharged Ford 4.6-liter V8.
By all accounts, it gets down the road just fine, and has pretty close to full power. The best part is, you can grow the fuel yourself and avoid patronizing big oil, if that's your thing. The only drawback that we can see to the Mercury Beaver XR-7 is the PVC pipe jungle occupying the space that would be the trunk under normal circumstances.
Still, if you're willing to smell like a mountain man and look like a bad Back to the Future knockoff, this ride is right up your alley. Click past the jump to see Translogic's take on this modified Merc.

Ford recalling 126,000 Fusions and Milans over wheel separation concern

Ford has announced a recall of certain Ford Fusion and Mercury Milan vehicles after an investigation by the National Highway Traffic Safety Administration. A total of 128,616 2010 and 2011 models equipped with steel wheels may have been manufactured with wheel studs that could crack and split over time. If that happens, the vehicle may experience a wheel separation.
According to The Detroit News, the company is aware of a total of 30 wheel separation incidents, one of which occurred on the front of the vehicle. Even so, no injuries have been reported as a result of the defect.
The problem apparently stems from the fact that the mounting pads on the vehicles' steel wheels may have been faulty from the factory. In addition, the wheel mounting face on rear disc brakes may not have been installed properly. Ford will inspect the rear disc face and replace them as necessary. In addition, the company will replace all of the vehicle's wheel studs free of charge. Head to the NHTSA website for more information, and click past the jump to view the full recall notice.