Beautiful 1982 Jeep Limited Grand Wagoneer on 2040-cars

Auto blog

Some Jeep Cherokees and Chrysler 200s to get standard stop-start in 2015

Automakers the world over are striving to find ways to make their models more efficient, and Chrysler has a solution for some versions of the 2015 Chrysler 200 and 2015 Jeep Cherokee (2014 model shown). The Tigershark 2.4-liter four-cylinder in the 200 and the 3.2-liter Pentastar V6 in the Cherokee are getting a slight boost later this year thanks to the addition of Chrysler's Engine Stop-Start system as standard equipment. The company predicts modest gains - a three-percent improvement in fuel economy and a three percent reduction in CO2 emissions with the new tech compared to without it. While it's not much, those who sit in traffic a lot may see a difference.
Chrysler's stop/start system uses a high-speed starter motor to restart the vehicle in a claimed a third of a second. It works by detecting when the vehicle comes to a stop and turning off the engine. A more powerful battery maintains all of the model's accessories while it sits. When the driver lets off the brake, the car starts up again to drive away. There is even a button in the cabin to turn the ESS off, if desired.
The Jeep will be the first to receive ESS in the third quarter of this year to coincide with the start of production of the 2015 model-year version. The 200 will follow in the fourth quarter as a rolling change in production.

NHTSA investigating power modules on Chrysler Group SUVs and minivans

The Center for Auto Safety is officially petitioning the National Highway Traffic Safety Administration to begin scrutinizing alleged problems with the totally integrated power module (TIPM) on about 24 Chrysler Group SUVs and minivans. The advocacy group claims that the part's failure can cause affected vehicles to stall or not start at all. NHTSA is still looking into the accusations and deciding whether a full investigation is actually warranted.
The CAS petition claims at least 70 TIPM failures, but according to NHTSA, six of the complaints are for models that don't have the modules. In 34 of the reported cases, the vehicles refused to start, and in 17 of them the engine stalled. There were also two allegations of smoke and one of a fire. However, none of these affected airbag deployment or resulted in a crash.
This petition isn't the first TIPM-related problem for Chrysler Group. A recent report in the New York Times alleged that it found 240 complaints potentially related to the issue on NHTSA's website alone. In September, the automaker also recalled 230,760 examples worldwide (188,723 in the US) of the 2011 Jeep Grand Cherokee and Dodge Durango replace the fuel pump relay circuit inside of the TIPM-7 with one external to the unit. The original part could allegedly cause the models to stall without warning. Even earlier, the company also recalled about 80,000 examples of the Jeep Wrangler and Dodge Nitro in 2007 to have the module reprogrammed.

Chrysler recalls small number of 2013-2014 cars and trucks over engine debris

Chrysler is recalling a small number cars over issues with their 2.4-liter four-cylinder engines. The recall, which affects 522 examples of its 2013 Dodge Avenger and Chrysler 200 models, as well as 2014 Jeep Compass and Patriot CUVs has to do with potential debris in the balance shaft bearings.
The abrasive stuff can cause the oil pressure to drop, which could lead to the engine stalling or outright failure. This situation could at best leave drivers stranded and at worst lead to a crash.
Chrysler will begin notifying owners, who will need to report in to have the balance shaft module replaced. All repairs are naturally free of charge. Scroll down for the bulletin from NHTSA.