2012 Honda Civic Si One Owner High Performance Lots Of Fun Sporty Wow!!! on 2040-cars

Auto blog

Honda S660 set for Yokkaichi production next year

Roadsters, you might argue, are best when they're small and nimble. If you're thinking of the Mazda MX-5 Miata, you're on the right track, but there have been even smaller ones: pint-sized, three-cylinder roadsters like the Daihatsu Copen, Suzuki Cappuccino and Smart Roadster. But the most iconic and enduring of them was surely the Honda Beat.
Designed by Pininfarina, the Beat was - not unlike the F40 was for Enzo Ferrari - the last car approved for production by company founder Soichiro Honda. It complied with Japan's strict Kei car regulations and packed a tiny, naturally aspirated 656 cc that produced just 63 horsepower. The cult classic ended production in 1996, but six months ago Honda hinted at a revival with the presentation of the S660 concept at the 2013 Tokyo Motor Show. Now it seems Honda - or Yachiyo, we should say - is gearing up to put it into production at the same factory that produced the Beat two decades ago.
That plant is the Yokkaichi factory, a facility owned by Yachiyo Industry Co., Ltd. that builds small cars on contract for Honda. It was slated for a major expansion a few years ago until Honda shifted some of its small car production to its own plant in Suzuka, but continues to build the N series of boxy, upright hatchbacks, as well as small commercial vehicles like the Life and Vamos lines. The reintroduction of a small roadster line to the factory's output sometime in 2015 will undoubtedly be a cause for celebration in Yokkaichi. For our part we can only hope that American Honda CEO Tetsuo Iwamura gets his way and manages to bring the S660 to the US in the near future.

2014 Honda HPD CR-Z

Honda invited us to its Southern California North American headquarters last week to take a spin in a very special CR-Z - one modified with a full complement of Honda Performance Development (HPD) components. While the company has been racing with HPD parts for years, this is the first time the automaker has offered them for its street-legal vehicles, and it has chosen this year's SEMA Show in Las Vegas to be the launch venue. Last year, Honda introduced the HPD Supercharged CR-Z Concept at SEMA - this is the slightly modified production version.
The complete transformation gives the normally placid hybrid hatchback a serious shot of adrenaline thanks to a bolt-on supercharger combined with suspension, tire, brake and exhaust upgrades. In addition to the blower (detailed in a bullet point below), new HPD suspension components lower the car by about half an inch, and firmer spring rates stiffen the ride. Stock 16- or 17-inch wheels are then replaced with HPD 18-inch alloys wrapped in sticky Michelin Pilot Super Sport tires (215/40ZR18 at all corners). The clutch is upgraded, a limited-slip differential is installed and new HPD monobloc four-piston calipers are fitted over slotted and ventilated iron rotors up front (the single-pistons over solid discs on the back axle are unchanged). In the rear, the stock hidden single exhaust pipe is replaced by a free-flow twin-tip exhaust that peers out of a new HPD lower diffuser. Other cosmetic enhancements include an HPD front lip spoiler, rear deck lid spoiler and an HPD emblem kit for each side. To say the CR-Z is transformed by the complete HPD package is an understatement.
Driving Notes

2015 Honda Fit production gets underway in Mexico

After two years of construction, Honda's new factory in Celaya, Mexico, has officially begun production of the all-new 2015 Fit in North America. Mexican President Enrique Pena Nieto and Honda President and CEO Takanobu Ito both attended the opening and watched the first Fit roll off the line at the $800-million plant. Later this year, Honda will add production of its new Vezel small crossover to the new facility, though the latter is expected to be marketed in North America under a new name.
The Celaya factory will specialize in building subcompact cars by employing cutting-edge tech to use less material and less energy during production. Honda is still constructing a $470-million transmission plant on the campus to build continuously variable transmissions in the second half of 2015. When it's finished, it is expected to have an annual capacity of 200,000 vehicles and employ 3,200 people.
With the facility's completion, Honda now has a 1.92-million unit annual production capacity in North America, and it claims that when Celaya reaches full production, 95-percent of vehicles sold in the US will be built in North America. The new Fit has already proven quite popular in Japan, and now we will have to wait and see if North American buyers embrace it as well. The first new Fit customer cars will hit the roads later this spring, and as Honda spokesman Steve Kinkade tells Autoblog, all Fit models sold in North American will be built at the plant. Scroll down to read the full press release about the Fit and its new Mexican home.