Beautiful Merlot 2004 Ford Thunderbird V8 on 2040-cars

Auto blog

J Mays retiring from Ford design, succeeded by Moray Callum

Ford's highly influential head of design, J Mays, has announced that he'll be retiring from his position after 33 years in the industry, 16 of which were at the Dearborn, MI-based company. Upon departure, he'll be succeeded as group vice president of design by Moray Callum. If that last name sounds familiar, yes, he's the brother of Jaguar's Ian Callum.
It's difficult to explain just how big of a role Mays had on not just Ford's design over the years, but on the entire industry. Before heading to Dearborn, Mays worked for Audi, BMW and then Volkswagen, where he was involved in concept cars that paved the way for design icons like the first-generation Audi TT and the Volkswagen New Beetle. As for his Ford resume, it's extensive.
Mays joined the company in 1997 as design director for Ford, Lincoln, Mercury and Mazda, as well as the Premier Automotive Group (Volvo, Land Rover, Jaguar and Aston Martin). He was heavily involved in the Ford Fusion, Focus, Fiesta, Taurus, F-150 and Mustang, while also contributing to concept cars like the Atlas, Evos, 427, Forty-Nine, Shelby GR-1, Lincoln MKZ and the MKC.

Fitting Retirement: Grand Marquis last Mercury off the line

The signs have come down and retail production ended back in October of 2010. Now, the very last Mercury model has rolled off the assembly line. This last Mercury somewhat fittingly takes the form of a Grand Marquis reporting for fleet duty. It was built at the St. Thomas plant in Ontario, Canada, which is the same facility that continues to produce the Ford Crown Victoria and Lincoln Town Car for fleet and livery duty.
St. Thomas' days are numbered, however, as the factory is slated to close on August 31. When it goes, the Panther platform is likely to follow. So long, and thanks for all the fish memories.
[Source: Autoweek]Read | Permalink | Email this | Comments

How Ford made its 2015 Ford Mustang safer for toupee wearers [w/video]

Ford is ready to tell the story of its 2015 Mustang Convertible, the can't-miss bits being the easier, quicker and quieter roof operation, a more robust roof build for a coupe-like cabin noise, more trunk space, better visibility and reduced in-cabin buffeting. The top release system has been completely redesigned with a single, center-mounted latch on the windshield frame instead of the dual latches of before. The driver can now release the roof without having to lean over into the passenger space, after which the top goes down fully automatically with the press of a button. Ford doesn't say how long it takes to stow, but it's apparently done in half as much time as before, so figure around 8 seconds.
The roof uses a five-bow structure, with the fabric outer and full inner headliner sandwiching ten millimeters of insulation. Detailing work on the top has eliminated "unsightly folds" in the corners when the roof is up and made it more compact when down; its Z-fold assembly is 6.7 inches lower than before at its highest point when put down. Ford says the new electric drive internals make less noise when in operation, and the fully-finished droptop look is achieved with snap-in caps that flank the rear seating and stow in the trunk when not in use (the outgoing Mustang's top was higher and the front when folded and always looked like it was catching air and creating drag).
The compact roof and newly independent rear suspension setup in back means liberated trunk space, 11.4 cubic feet ready to swallow golf bags and tourist swag. You can read a lot more about it in the press release below, check it out in the short video of running footage and learn about the aerodynamic improvements made to the entire Mustang lineup that decrease drag and increase fuel economy.