2011 Ford Ranger Xlt 4dr Supercab 4 X 4 5-speed Automatic on 2040-cars

Auto blog

Hennessey Ford GT sets 267.6-MPH record at Texas Mile [w/videos]

The record-setting Hennessey-powered camouflage Ford GT we showed you at this time last year headed back to the Texas Mile and managed to bring home yet another record. As you may recollect, last year saw Mark Heidraker's machine sprint to a record 257.7 mph thanks to propulsion from its twin-turbo 5.7-liter V8. The big mill sucks down race gas, and this year the creation pulled off a 267.6-mph run over the weekend. That feat set a new record for the event. Something tells us neither Heidraker nor Hennessey are done squeezing more thrust from this machine.
This particular Ford GT has already gone through a number of permutations. Hennessey started by tweaking the factory supercharger set up before abandoning the blower in favor of two turbos. Since then, the crew has poked and prodded it to coerce as much grunt as possible out of the car. We expect Hennessey will probably come out with a video of the record-setting run shortly, but in the meantime, you can see a couple of videos of the car's runs in Texas below (one of which actually captures the record run). Enjoy.

NHTSA upgrades Ford floor mat unintended acceleration probe

According to a Bloomberg report, the National Highway Traffic Safety Administration has upgraded an investigation into complaints of unintended acceleration lodged against Ford vehicles. The investigation began in June of 2010 when just three complaints had been received and it only concerned the Ford Fusion and Mercury Milan, but this was at a time when the phrase "unintended acceleration" made grown men go pale. With 49 additional complaints received since then, the investigation has been reclassified as an engineering analysis - the last phase before a recall - and it has been expanded to include the Lincoln MKZ, making for a total of "around 480,000" units affected between the three sedans from the 2008 to 2010 model years.
The ostensible cause is that floor mats are trapping the accelerator pedal, but according to a Ford statement at the time, the entrapment is due to owners placing the optional all-weather floor mats, or aftermarket floor mats, on top of the car's standard floor mats. NHTSA has backed up that assessment, pinning the blame on "unsecured or double stacked floor mats."
On the face of it, it would appear that NHTSA has upgraded the status not because of Ford's error, but owner error, and Ford has stated publicly that it is "disappointed" in NHTSA's move. On top of NHTSA still being skittish after that other unintended acceleration debacle, it could be seen to be taking its time investigating all of the variables: it's reported that Ford changed its accelerator pedal design in 2010, a "heel blocker" in the floorpan has been considered a potential culprit in how the floor mats could be trapping the pedal, some drivers have said the floor mats weren't anywhere near the pedal, and according to a report in the LA Times, in "a letter sent by Ford to NHTSA in August 2010, the automaker said it found three injuries and one fatality that 'may have resulted from the alleged defect.'"

NHTSA closes Ford F-Series Super Duty steering probe without recall

The National Highway Traffic Safety Administration's investigation into 2008 Ford F-250 and F-350 Super Duty pickups, which was originally opened last year, has now ended without a recall. NHTSA was looking into steering failures on some 336,000 trucks.
The issue rested with the steering gear - NHTSA received five complaints of failures - which was redesigned in 2005. According to the report on the matter, investigators "found evidence of broken sector shaft gear teeth and piston damage consistent with incidents of single event overload."
NHTSA investigators, however, "found no evidence of fatigue or material property defects in any of the fractures. Analysis of complaint rates by vehicle build month showed no patterns indicating potential manufacturing quality issues and no difference before and after Ford introduced design changes to the input shaft and sector shaft seals in July 2007 to address potential leak concerns," according to the report, obtained by The Detroit News.