1942 Ford 1/2 Ton Pickup~rare Find on 2040-cars
York, South Carolina, United States
SERIOUS BIDDERS ONLY!!! THE LAST TWO BUYERS BACKED OUT FOR NO APPARENT REASON~~~PLEASE DO NOT BID UNLESS YOU ARE SERIOUS.
Keep in mind this truck is 72 years old, it is in great shape and restoration is not complete.This is a survivor before Ford shut down production to turn over their factory for the war effort. The only produced these for a few months. Vehicle is sold as is. The engine runs strong and I believe it is the original Flathead V8, it was changed over to 12 volt. The following has been done mechanically: I have replaced the complete fuel system, new gas tank, sending unit, fuel lines, fuel pump, spark plugs & wires and carburetor. The wiring has all been replaced except the front end light harnesses's. Re-cored radiator, upper & lower radiator hoses replaced, radiator pipes replaced with stainless steel, new thermostats, new batteries(2 6 volt batteries included) new starter and and original starter. New motor mounts. All hoses and belts have been replaced. New water pump. Instrument cluster was completely rebuilt & re calibrated like new. New head light switch and harness, starter button. Original heater, no leaks Floor panels patched(see pictures) Needs wiper motor, New hinge pins & bolts. 4 almost new white wide wall tires with little wear, other than me test driving. I have over $5200. in receipts for parts and items that have been repaired or replaced. I have NOS muffler, stainless grill "jail bars", chrome plated hood latch assembly, chrome left mirror, new running boards, new tail gate, headliner and interior kit with panels. Dimmer switch. These repairs seems to have been done by the previous owner: Brake lines and brakes, exterior work , wood floor for bed with stainless strips(see picture) rear bed corners by tailgate. Some rear spring leaf's have been removed to lower. I have these also. It appears to have the original blue paint and then the dark green as seen in the picture. The body does need some work but I feel it wouldn't take much to get it ready. I have additional pictures that I can send. If interested please email me. I . |
Ford Other Pickups for Sale
- 1948-50 ford f2 parts for sale(US $2,000.00)
- Rat rod street rod truck air ride bbf
- 2008 ford f550 powerstroke 6.4 diesel cab and chassis drw low miles low reserve
- 1934 ford pickup truck rat rod bagged 1st place detroit autorama no reserve(US $25,000.00)
- 1939 ford pickup truck street rod(US $27,889.00)
- Very cool 1936 ford tow truck,vintage wrecker
Auto Services in South Carolina
University Tire and Muffler ★★★★★
Tint Plus of Anderson ★★★★★
Sterling`s Detail ★★★★★
Southern Customs Body Paint Frame & Collision ★★★★★
Southern Automotive ★★★★★
Sisk Family Ford ★★★★★
Auto blog
How Ford made its 2015 Ford Mustang safer for toupee wearers [w/video]
Fri, 28 Feb 2014Ford is ready to tell the story of its 2015 Mustang Convertible, the can't-miss bits being the easier, quicker and quieter roof operation, a more robust roof build for a coupe-like cabin noise, more trunk space, better visibility and reduced in-cabin buffeting. The top release system has been completely redesigned with a single, center-mounted latch on the windshield frame instead of the dual latches of before. The driver can now release the roof without having to lean over into the passenger space, after which the top goes down fully automatically with the press of a button. Ford doesn't say how long it takes to stow, but it's apparently done in half as much time as before, so figure around 8 seconds.
The roof uses a five-bow structure, with the fabric outer and full inner headliner sandwiching ten millimeters of insulation. Detailing work on the top has eliminated "unsightly folds" in the corners when the roof is up and made it more compact when down; its Z-fold assembly is 6.7 inches lower than before at its highest point when put down. Ford says the new electric drive internals make less noise when in operation, and the fully-finished droptop look is achieved with snap-in caps that flank the rear seating and stow in the trunk when not in use (the outgoing Mustang's top was higher and the front when folded and always looked like it was catching air and creating drag).
The compact roof and newly independent rear suspension setup in back means liberated trunk space, 11.4 cubic feet ready to swallow golf bags and tourist swag. You can read a lot more about it in the press release below, check it out in the short video of running footage and learn about the aerodynamic improvements made to the entire Mustang lineup that decrease drag and increase fuel economy.
Ford begins testing right-hand-drive Mustang
Wed, 20 Aug 2014Ford has officially kicked off testing of the right-hand-drive variant of its sixth-generation, 2015 Mustang, according to a statement issued by the company, which came with the above photo.
According to Ford, this will mark the first time a right-hand-drive 'Stang has traveled down the company's assembly line alongside its LHD brethren. It is far from the first of the legendary pony cars to feature its wheel on the wrong side, though, as converters in RHD markets across the globe have been making swaps for years.
Ford is planning on using the white, droptop Mustang for RHD development ahead of the car's arrival in the UK, Australia and South Africa, among other markets. Scroll down for the official press blast.
Next Ford Mustang to drop 400 pounds
Thu, 15 Aug 2013The Ford Mustang is already the lightest of the current crop of muscle cars, at around 3,600 pounds for a GT coupe with the six-speed manual transmission. That's almost 260 pounds less than a Chevrolet Camaro SS and about 450 pounds less than a Dodge Challenger R/T, which means the Mustang has a pretty big advantage when it comes to handling, braking, accelerating and economy. More good news: The next Mustang will be even lighter.
According to a report from Edmunds, the sixth-generation Mustang, which is set to debut at the 2014 North American International Auto Show, will shed an additional 400 pounds of body fat. That 11-percent weight reduction will be thanks to lightweight materials, with a particular focus on using stronger, but less material in construction. Aluminum will feature heavily, but Edmunds' inside source warns that there is "nothing terribly exotic" coming to the original pony car.
The other big news is that the new Mustang will be smaller overall. It's going to be 15-inches shorter than the 188.5-inch Mustang on sale today, while it'll also be 6.5 inches narrower. Shorter overhangs, both in the front and rear, are also good signs for those that want an agile Mustang.