White/black & Cashere Leather,chrome 19's,heated Pwr Seats,3.73's,flowmasters!!! on 2040-cars

Auto blog

What an Atlas-based Ford F-150 might look like

Just ahead of January's Detroit Auto Show, surprising rumors pegged Ford as revealing some sort of F-150 concept, perhaps as a hurried effort to deflate some of the buzz building around General Motors' new Chevrolet Silverado and GMC Sierra twins, which were also making their auto show debut. Those rumblings turned out to be true, as Ford rolled into the Motor City with its Atlas concept (inset, right), touting the truck's bold styling as a precursor to the next-generation F-Series.
The show truck featured all kinds of clever details, including active wheel shutters and a front air dam that raised and lowered to improve aerodynamics while preserving off-road ability. It also had a genuinely snarly face. And it's that pugnacious snout that may well be on its way to production. The good folks at TopSpeed have worked up the plausible-looking artist's rendering above by cross-referencing the Atlas concept with what little has been revealed from recent spy shots. The look is toned-down pretty dramatically from the concept truck, but its Atlas roots are clear, with a massive three-bar grille and bracket-shaped headlamps hiding a next-generation EcoBoost engine. In the rendering, the show truck's deeply contoured hood and roofline have been ditched and larger, more traditional side mirrors have been fitted - all likely concessions in the move to production sheetmetal.
While Ford has yet to officially announce when it will unveil the 2015 F-150, all signs point to next year's Detroit Auto Show - one year after the Atlas shrugged off GM's new pickups.

Ford reveals new rapid prototyping and low-volume production techniques [w/video]

It's called "F3T," and that stands for Ford Free-form Fabrication Technology. The process that The Blue Oval has developed means being able to sidestep the weeks-long process of tool-and-die making when engineers want to construct a new part, allowing them to fabricate a three-dimensional part from a two-dimensional sheet of metal in just hours.
While F3T is being developed it is limited to "low-volume prototyping or even low-volume niche vehicles," but the next step is to evaluate it for use in Ford's global manufacturing facilities. You can find out more about it in the video and the press release below.

NHTSA closes probes on Jeep Grand Cherokee, Ford Freestar and Mercury Monterey

The Detroit News reports the National Highway Traffic Safety Administration has officially closed its investigations into 2012 Jeep Grand Cherokee, 2004-2005 Ford Freestar and Mercury Monterey models. The separate probes found no issues that pose safety concerns. NHTSA began investigating certain Grand Cherokee SUVs over complaints that power steering hoses could detach during operation, thereby increasing the risk of a vehicle fire. Of the 24 reports of failure, none alleged smoke or fire in the engine bay, and Chrysler has since modified the power steering cooler assembly to reduce the likelihood of the failure.
Meanwhile, certain Ford Freestar and Mercury Monterey vehicles garnered a government probe after receiving complaints that the models were equipped with faulty scissor jacks. The agency had received six reports of the jacks failing or causing injuries, including one incident that resulted in a fatality. But NHTSA says the jack failure rate is similar to those found in other vehicles. In those six cases, the government agency found the jacks were being used for something other than changing a tire, and investigators could not determine whether the emergency brake was set or the rear tires were properly chocked.