2003 Ford Mustang on 2040-cars

Auto blog

Ford builds Lightweight Concept with Fusion shell [w/video]

It's a fairly well known fact that removing weight from a car is essentially a panacea for many of the modern automobiles problems. Does it handle like crap? Remove weight. Underpowered? Don't add power; trim the fat. Need to improve fuel economy? It's diet time.
Actually executing a major weight reduction program, though, much like with human beings, is no easy task. Unlike you or I, where motivation is the issue, the prohibitive measure in trimming a car's waistline is money. Lightweight materials are expensive, with carbon fiber and carbon-fiber reinforced plastic still primarily in the domain of higher end vehicles. Even aluminum construction, pioneered on a mass-produced level by Audi and Jaguar, is only now starting to make its way into the mainstream, thanks to the upcoming Ford F-150.
With this concept, though, Ford is attempting to show that a mass-produced, lightweight vehicle isn't too far off. This is the Lightweight Concept, and while it may look like a Fusion, it weighs as much as a Fiesta. For reference, the lightest Fusion available to the public is the 3,323-pound, 2.5-liter model with a manual transmission. A manually equipped, 1.6-liter Fiesta, meanwhile, is just 2,537 pounds.

What an Atlas-based Ford F-150 might look like

Just ahead of January's Detroit Auto Show, surprising rumors pegged Ford as revealing some sort of F-150 concept, perhaps as a hurried effort to deflate some of the buzz building around General Motors' new Chevrolet Silverado and GMC Sierra twins, which were also making their auto show debut. Those rumblings turned out to be true, as Ford rolled into the Motor City with its Atlas concept (inset, right), touting the truck's bold styling as a precursor to the next-generation F-Series.
The show truck featured all kinds of clever details, including active wheel shutters and a front air dam that raised and lowered to improve aerodynamics while preserving off-road ability. It also had a genuinely snarly face. And it's that pugnacious snout that may well be on its way to production. The good folks at TopSpeed have worked up the plausible-looking artist's rendering above by cross-referencing the Atlas concept with what little has been revealed from recent spy shots. The look is toned-down pretty dramatically from the concept truck, but its Atlas roots are clear, with a massive three-bar grille and bracket-shaped headlamps hiding a next-generation EcoBoost engine. In the rendering, the show truck's deeply contoured hood and roofline have been ditched and larger, more traditional side mirrors have been fitted - all likely concessions in the move to production sheetmetal.
While Ford has yet to officially announce when it will unveil the 2015 F-150, all signs point to next year's Detroit Auto Show - one year after the Atlas shrugged off GM's new pickups.

NHTSA and Ford investigating steering issues in Crown Vic, Grand Marquis and Marauder

There may be more steering woes for the Ford Crown Victoria. The National Highway Traffic Safety Administration has opened a preliminary evaluation into the Crown Vic and Mercury Grand Marquis from the 2004 to 2007 model years and the Mercury Marauder for the 2004 and 2005 model years because the steering shaft can jam. The issue could potentially affect an estimated 500,000 vehicles.
According to the regulator, there is a possibility that the driver's side heat shield for the exhaust manifold can rust, dislodge, and then wedge into the steering shaft. If this occurs, it leads to a situation where the driver can no longer control the car.
NHTSA has received five complaints of this happening, including one alleged case with an injury. In that situation, the car was driving onto the highway, lost control and rolled over. One occupant was hurt in the accident.