(1931 Ford 2dr Sedan And Custom Trailer Combo) Straight Out Of The 80's Awesome! on 2040-cars

Auto blog

BMW V8-powered Ford Model A is the definition of Hot Rod

Today, hotrodding has a pretty staid definition. Take one classic American car, add one classic American V8, sprinkle with tire smoke and you pretty much have every hot rod to roll out of a shop in the last 40 years. Mike Borroughs knows it wasn't always this way. Once upon a time, getting your bucket to go faster meant grabbing whatever parts were lazing about the yard, bolting them together with a bit of ingenuity and laughing your way down the quarter mile. It's in that spirit that Burroughs built his 1928 Ford Model A.
Rather than turn to the tired flathead or the common Chevrolet small block, Burroughs plucked a 4.0-liter V8 from a 1995 BMW 7 Series. With 300 horsepower and 300 pound-feet of torque, the engine has no trouble shuffling the old A around town. He had to build a custom chassis to get everything to cooperate, but the result is a 1,500-pound heathen that looks built to harass dry lake beds. You can check it out in the video below. Be warned, the soundtrack by Hanni el Khatib may not be safe for work - awesomeness of this caliber rarely is.

Shelby to auction 2012 GT350 No. 1 in Vegas

With Shelby preparing to wind down production of its brutal GT350, a 624-horsepower Mustang that's meant to go up against the Roush Stage 3 in the world of tuned Ford ponycars, the Las Vegas-based tuner is looking to give back to one lucky customer. It'll auction off the very first GT350 ever produced, at the 2013 Barrett-Jackson auction in Las Vegas, a three-day event that runs from September 26 through September 28.
The GT350 is a monster, with a 5.0-liter, supercharged V8 that's been tuned well past 600 horsepower in a time when Ford's own Shelby-branded GT500 barely reached 550 horsepower. The GT350 is much louder than Ford's effort, too, both visually and audibly. The wide body look isn't what we'd call conventional, but on a car that sounds and goes like this, something extreme is needed. According to Shelby American's vice president of production, Gary Davis, "Carroll was very excited about the new wide body option, so that was included on this car. It's the first 2012 GT350 serial number from our anniversary year. It is a very special car." Wilwood brakes, a massaged suspension, and some very fat, sticky tires add to the Shelby experience.
This particular GT350 will be lot number 750, and will cross the Barrett-Jackson stage on Sunday, September 28.

2014 Ford Transit unveiled in Chassis Cab and Cutaway versions

As a leader in commercial vehicles here in the US, we knew Ford wouldn't take too long to show off the chassis cab and cutaway versions of its 2014 Ford Transit van. Set to go on sale this fall, Ford already revealed the full-body version of the Transit, and now it has pulled the cover off exposed-frame models just in time to to compete against the all-new Ram Promaster.
The term "chassis cab" refers to models with a fully enclosed cabin used for box vans or rental trucks, while cutaway models leave the cabin open behind the B-pillars for a pass-through on vehicles such as Class C motorhomes or ambulances. Both will offer three wheelbase options (138, 156 and 178 inches), the choice of single or dually rear axles, and plenty of upfitter-friendly touches including a pre-wired body harness and multiple body mount locations.
The new design will also help make upfitting a little easier since the fuel filler is now built into the cab (just behind the driver's door). Those integrated fuel filler necks will serve to feed either a 3.7-liter V6, a 3.5-liter EcoBoost V6, or a 3.2-liter Power Stroke diesel. Transit chassis cab and cutaways will wear varying Gross vehicle weight ratings from 9,000 pounds to 10,360 pounds depending on spec.