1965 Ford Falcon 2 Dr Sedan Classic Rat Rod Gasser on 2040-cars

Auto blog

2013 Ford Mustang V6

Secretary Trim, Evolved
There was a time not so long ago when opting for a base Ford Mustang meant getting little more than some sheetmetal, an anemic four-cylinder engine and what may very well have been the world's most disappointing automatic transmission. During the Fox Body years, Ford seemed hell-bent on living up to Carroll Shelby's derogatory description of the coupe as little more than a runabout for demure office assistants, and the result was a base model with fewer sporting intentions than a Dilbert day calendar.
Some 20 years later, hopping behind the wheel of an entry-level pony is an entirely different experience. With all of the menacing aesthetics of the brawnier GT, a well-equipped interior and a drivetrain that toes the line between efficiency and power better than few before it, the 2013 Ford Mustang V6 is an attractive option for buyers in the big coupe market. But is it attractive enough to forgo the beastly GT?

Ring Brothers shows 1965-66 Mustang fastback carbon fiber body

We covered one of Ring Brothers' more extreme SEMA builds yesterday, the De Tomaso Pantera-based ADRNLN, but if that well-executed but over-the-top Italian-American exotic is too much for you, then perhaps this Ring Brothers 1965 Ford Mustang fastback with a carbon-fiber body suits your tastes better.
What the performance-parts manufacturer is showcasing with the Mustang is the carbon-fiber body itself, which is fashioned around the 1965-66 fastback. It can be bought from the company and bonded to the skin and unibody as a do-it-yourself project, or you can take your Mustang to Ring Brothers and have the body installed there. The fenders, doors and quarter panels are two-inches wider than stock, and Ring Brothers offers a custom widebody chassis to those who want the complete package.
The show car looks sharp in person lowered on HRE wheels, and we appreciate the bare front end so we can see the supercharged V8 and front coilover suspension, though the details on those performance upgrades are slim. Also note the custom independent rear suspension setup at the rear.

Ford, GM to collaborate on 9- and 10-speed transmissions

Back in October, there were reports that General Motors and Ford Motor Company were hard at work co-developing new nine- and ten-speed automatic transmissions, and now both automakers have confirmed this joint operation. While there are no specific vehicles mentioned to receive either transmission, a collaborative press release issued by GM and Ford mention that the transmission will be designed for front- and rear-wheel-drive cars, crossovers, trucks and SUVs.
These aren't the first powertrain components developed jointly between these cross-town rivals, either. The six-speed automatic currently used in vehicles like the Ford Edge, Ford Fusion, Chevrolet Cruze and Chevrolet Equinox was engineered in a similar fashion. As is the case with this existing transmission, both automakers will assist in the design, development and testing of the new transmissions, but each will build its own units in its own factories. Scroll down for the official press release.