Find or Sell Used Cars, Trucks, and SUVs in USA

1955 Ford F 100 Pickup on 2040-cars

Year:1955 Mileage:28028
Location:

Scottsdale, Arizona, United States

Scottsdale, Arizona, United States

This Truck is in excellent condition. It underwent a full Frame-Off Restoration.
  • 9" Ford Rear End
  • V. D. O. Custom Gauges
  • Tunnel Port Fuel Injected
  • Vintage In-Dash Air Conditioning
  • Tilt and Telescoping Steering Wheel
  • Power Steering
  • Disc Brakes
  • Custom Interior with Overhead Console
  • Custom 200 SX Door Handles
  • Custom Sliding Rear Window
  • 33 Gallon Rear Gas Tank
  • Custom Gaylord Bed Cover
  • Remote Gas Filler Lid
  • Volari Front End
  • Newly rebuilt Transmission
  • Pinstriping and Graphics
  • Custom Rims
  • P225/70 R15 like new Tires
Brand New Leather Bucket Seats with Center Console. This is a fun Truck, handles well and could easily become your daily driver.

Auto Services in Arizona

V I Auto Repair ★★★★★

Auto Repair & Service, Brake Repair
Address: 701 W Bethany Home Rd, Glendale-Luke-Afb
Phone: (602) 841-4394

TIC Automotive ★★★★★

Auto Repair & Service, Air Conditioning Service & Repair, Emission Repair-Automobile & Truck
Address: 5310 E Northgate Loop Suite D, Flagstaff
Phone: (928) 526-0966

Suiter`s Automotive ★★★★★

Auto Repair & Service, Used Car Dealers, Wholesale Used Car Dealers
Address: 11049 N 23rd Ave Ste B1, Glendale-Luke-Afb
Phone: (602) 943-6225

Sav-On Transmission ★★★★★

Auto Repair & Service, Auto Transmission
Address: 3701 N 43rd Ave, Luke-Afb
Phone: (602) 272-1605

Ronnie`s Auto Service ★★★★★

Auto Repair & Service
Address: 527 W University Dr, Guadalupe
Phone: (480) 967-8869

Red`s Collision Service ★★★★★

Automobile Body Repairing & Painting
Address: 22039 N 24th Ave, Youngtown
Phone: (623) 869-0813

Auto blog

NHTSA closes Ford F-Series Super Duty steering probe without recall

Wed, 05 Feb 2014

The National Highway Traffic Safety Administration's investigation into 2008 Ford F-250 and F-350 Super Duty pickups, which was originally opened last year, has now ended without a recall. NHTSA was looking into steering failures on some 336,000 trucks.
The issue rested with the steering gear - NHTSA received five complaints of failures - which was redesigned in 2005. According to the report on the matter, investigators "found evidence of broken sector shaft gear teeth and piston damage consistent with incidents of single event overload."
NHTSA investigators, however, "found no evidence of fatigue or material property defects in any of the fractures. Analysis of complaint rates by vehicle build month showed no patterns indicating potential manufacturing quality issues and no difference before and after Ford introduced design changes to the input shaft and sector shaft seals in July 2007 to address potential leak concerns," according to the report, obtained by The Detroit News.

2014 Ford Mustang GT

Fri, 17 May 2013

I was more than a year removed from my last experience with the Mustang GT and its delicious 5.0 V8 when this new 2014 example rolled up to my driveway recently. Good weather and a planned road trip across the state meant that I would get plenty of seat time in this conservatively specified example, too. In total, I logged about 400 miles in a week of driving - not a lot for some of you super commuters out there, but quite a lot for this work-from-home journalist.
The basic formula of the 5.0 has stayed the same for 2014. The 2013 model year saw a number of updates to keep the Mustang fresh until it's replaced with an all-new generation for 2015. So, for its bon voyage tour, the fifth-generation Pony Car has seen only a few modifications: a couple of new paint colors (Oxford White and Ruby Read Metallic), trim and wheel revisions and, sadly, the deletion of the Boss 302 from the Ford lineup. However, while the limited-edition Boss is likely to reappear sometime after the gen-six Mustang makes its debut in 2015, the GT Track Package cars like the one I tested provide at least a partial solution for those looking for hot laps.
Driving Notes

Ford cleans up painting process with cameras

Thu, 22 Aug 2013

Knowing how the bacon gets made rarely entices us and, in the same vein, the same usually goes for knowing about how new cars get painted. But in both instances, however, quality - or a lack thereof - is instantly obvious. In terms of the latter, Ford is showing off its new paint quality process with 3D Dirt Detection Technology to find imperfections in vehicle paint more easily and more quickly.
This process - being performed on the F-150 SVT Raptor above - uses 16 computer-controlled cameras to create a three-dimensional model (inset) of the vehicle to detect flaws in the paint including dirt particles, which can then be buffed out manually. Ford says this new technology cuts down on time spent looking for paint flaws and gives workers more time to correct those that are discovered.
Currently, Ford only uses its 3D Dirt Detection Technology system at three factories (the Dearborn, MI facility, along with those in Louisville, Kentucky and Valencia, Spain), but it will soon spread to five more plants in North America. Ford has released a video and press release for this innovative and unexpectedly interesting process, both of which are posted below.