Find or Sell Used Cars, Trucks, and SUVs in USA

1949 Ford Pickup on 2040-cars

Year:1949 Mileage:30594
Location:

Hiawatha, Kansas, United States

Hiawatha, Kansas, United States
Vehicle Title:Clear
VIN: 98RT239750 Year: 1949
Mileage: 30,594
Make: Ford
Warranty: Vehicle does NOT have an existing warranty
Model: F-100
Condition: Used: A vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections. ... 

         This is a 1949 ford 1/2 ton pickup. It has one of the best cabs I've seen in a long time. The cab, front fenders, hood, and engine came from a F-5 stake truck that had been in a barn for 20 plus years. The F-5 fenders have a bigger opening than F-1's and so they hang down below the running boards about 2 inches. They were so nice and have the great original patina I left them on it.  The only rust is the lower left fender apron below the headlight and the right door looks thin on the inside inner part where it meets the cab. I wish I could find a bed and rear fenders to match.The chassis is 1/2 ton with new brake cylinders, brake shoes, master cylinder,all hoses and lines. It still could have the drums turned or replaced but not totally necessary. They are rusty, It needs 2 studs replaced on the right front hub. It needs a muffler and tail/brake lights. The running boards have rust where the rear cross brace is. The bed and tail gate are near excellent with the exception the bed is the one that takes wood and metal dividers. It needs new wood and could use a couple better divider stripes. Again I haven't sand blasted and primed the rear 1/2 the truck yet as it has some rough patina as it is. If I could put red primmer with new rubbed through green paint that's my plan. The rear fenders have rust where they meet the running boards, behind the wheel where the brace attaches, and where the bed and fender meet as it curves down in the back. It could use better rears if you could find them. The engine sounds good from yard driven. When you 1st start it the valves pop and bang, but a little upper lube I think the engine is good. I think the park and headlights work as my brother did the changeover and I haven't checked. The big truck wireing is there for the tail lights. He did say the generator or voltage regulator needs repaired.  The speedomter reads 30,594 which is from the cab. It may be accurate for the cab and engine but the needle has fallen off from age and the cable isn't currently hooked up. I may buff the cab and front 1/2 but wanted to show them as barn fresh. Hope you like it that way also. A 500.00 non refundable deposit is due within 48 hours and the balance within 7 day's. I am a Kansas dealer so Kansas residents need to add 8.8% sales tax. Other states pay in your home state. It's sold with Implied warranty only meaning the buyer payes for all repairs. I currently have the truck in North Kansas City, Mo where I'm moveing to if you want to look. I can also have it back in Hiawatha, ks whichever is easier.  Thanks, Scott 816-506-3789 


On Mar-30-13 at 11:17:38 PDT, seller added the following information:

 I just drove the truck and the generator does work as do the park lights and headlights.   I want to add  the truck is for sale locally and I reserve the right to end the auction at any time. Thanks again, Scott      4/14/2013     I wanted to add I change the wheels are now late model 15 inch pickup  all the way around. It did have earlier smoothies for early hubcaps. It's selling with the late model wheels. I have washed the oxidation off and I'm getting ready to polich the front if the weather will stay nice.   Thanks, Scott

Auto Services in Kansas

Yost Auto Service ★★★★★

Auto Repair & Service, Auto Oil & Lube, Truck Service & Repair
Address: 1818 E 2nd St N, Bel-Aire
Phone: (316) 264-8482

Weavers Alignment Inc ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Mufflers & Exhaust Systems
Address: 420 S Washington Ave, Liberal
Phone: (620) 624-7218

Valvoline Instant Oil Change ★★★★★

Auto Repair & Service, Auto Oil & Lube, Automotive Tune Up Service
Address: 10150 Wornall Rd, Overland-Park
Phone: (913) 677-4777

Shorey Automotive ★★★★★

Auto Repair & Service, Automobile Air Conditioning Equipment-Service & Repair, Auto Oil & Lube
Address: 1432 NW Eugene St, Topeka
Phone: (785) 232-3877

Sexson Economy Muffler ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Mufflers & Exhaust Systems
Address: 10908 E US Highway 40, Mission-Woods
Phone: (816) 356-2276

Pro-Tek Dent & Windshield Repair ★★★★★

Automobile Body Repairing & Painting, Automobile Parts & Supplies, Windshield Repair
Address: Wilmore
Phone: (620) 626-4108

Auto blog

Ford dealers offered discounts on tools to fix aluminum

Mon, 27 Jan 2014

With the introduction of the aluminum-bodied 2015 Ford F-150 (and the likely use of aluminum in future Ford products), Ford is looking to help its dealerships reduce costs related to repairing this more labor-intensive material. Automotive News is reporting that Ford dealers with body shops will require an estimated $30,000 to $50,000 in equipment and training to work on aluminum, and to help alleviate the financial burden of the new F-150, Ford has announced a special 20-percent discount on this equipment.
Dealers will be able to save up to $10,000 on tools such as welders, air-filtration systems and rivet guns and to create aluminum-specific work stations. The new F-150 goes on sale in the fourth quarter, and dealers have until October 31 to take advantage of this deal, according to the report.

How Ford hid the 2015 Mustang from spy photographers

Fri, 20 Dec 2013

Now that we've finally seen the 2015 Ford Mustang, it's fun to go back and look at the spy shots we spent months pouring over, trying to dissect what was under all the camouflage. For the most part, Ford did a good job of concealing the car from spy photographers, and it released a video showing how much work went into doing so.
As crude as the Mustang's camo looked, all of the hard plastic, foam, vinyl and ratchet straps were actually created and put in place by a specific design team. The whole idea was to hide the car's identity, but it certainly ended up acting as a magnet for attention, too. According to Ford's press release, it took less than an hour for spy shots to appear online after the car was taken on public roads for the very first time - this is likely in reference to our first official spy shots of the Mustang from June, shown in the gallery below.
Scroll down for a press release and video, which shows footage of the 2015 Ford Mustang testing with minimal camouflage. This is probably the same track session where we got our first look at the Mustang's face back in August.

Ford unveils its facelifted Falcon finale with new XR8

Thu, 24 Jul 2014

While its days may be numbered, Ford isn't just going to let its Falcon sedan limp out for the Australian market. No, the Blue Oval is releasing a refreshed Falcon for its final years, and it's lead by this, the new XR8. That's right, this dead-car-driving is going to go out on a high note.
Ford's global design DNA dominates the looks of the new Falcon, with a grille reminiscent of the US market Fusion and the European-market Mondeo. The headlights aren't a straight port, and boast their own unique LED running light pattern (at least on the XR8), but the overall look is strikingly similar. Out back, LED taillights highlight the rear of the Faclon. Despite the substantial new fascia, this is still a mid-cycle refresh. That means most of the rest of the Falcon's body panels are carryovers from the current model.
The XR8 model, shown above, arrives with a supercharged V8, allegedly displacing 5.0 liters. Unfortunately, details on the Falcon's mechanicals are in remarkably short supply. Ford has committed to a range of turbocharged four, as well as turbocharged and naturally aspirated six-cylinders, in addition to the V8, although specifics on those mills aren't available.