2003 Ford E150 Wheel Chair Van Low Miles Xlt Rear Lift 1 Owner on 2040-cars

Auto blog

2015 Ford Mustang to offer solid-rear axle, sort of

One of the biggest knocks against the last Ford Mustang was its solid-rear axle. Not one to actively court criticism, Ford dutifully swapped out the old-fashioned rear end for something a bit more modern in the redesigned 2015 Mustang, adding an independent rear suspension across the board.
While an IRS Mustang is great news for those that value handling and ride comfort, there's one big group that it's bad news for - drag racers. See, a solid-rear axle is a big deal for drag racers, because not only is it more durable and cheaper, but it's better for the hard launches that can make or break a race.
To satiate this vocal demographic, Ford will sell a body-in-white version of the Stang, complete with a nine-inch rear axle, that will debut at the 2014 Performance Racing Industry show. The news came from gas2.org, which cited an unnamed employee of Ford Racing at this year's PRI show.

VW going turbo-only in 3 to 4 years

This really was a matter of when, rather than if. Volkswagen will apparently be the first manufacturer to phase out naturally aspirated engines in favor of turbocharging its full slate. VW is kind of responsible for ushering in this push towards small-displacement, turbocharged engines that's taken the industry by storm. When it dropped its direct-injection, 2.0-liter turbo in the 2005 GTI it demonstrated that strapping an iron long to an engine can enhance the powertrain as a whole. VW made fuel economy gains, while also giving a linear, non-laggy turbo experience that it has replicated, model-after-model, to this day.
Speaking with The Detroit News, Volkswagen's executive Vice President of Group Quality, Marc Trahan, told the paper that, "We only have one normally aspirated gas engine, and when we go to the next generation vehicle that it's in, it will be replaced. So three, four years maximum."
Really, it's hard to get teary-eyed about either of these engines going away. VW has access to smaller powerplants that could easily match the performance of the 2.5 five-cylinder and the 3.6 V6, while gobbling up less fuel and providing a better driving experience. What we are sad about is that a similar statement about the extinction of NA engines came from the Vice President of Powertrain Engineering at Ford, Joe Bakaj. We'd certainly get teary-eyed over a world without Ford's excellent 5.0-liter V8.

Ford builds Lightweight Concept with Fusion shell [w/video]

It's a fairly well known fact that removing weight from a car is essentially a panacea for many of the modern automobiles problems. Does it handle like crap? Remove weight. Underpowered? Don't add power; trim the fat. Need to improve fuel economy? It's diet time.
Actually executing a major weight reduction program, though, much like with human beings, is no easy task. Unlike you or I, where motivation is the issue, the prohibitive measure in trimming a car's waistline is money. Lightweight materials are expensive, with carbon fiber and carbon-fiber reinforced plastic still primarily in the domain of higher end vehicles. Even aluminum construction, pioneered on a mass-produced level by Audi and Jaguar, is only now starting to make its way into the mainstream, thanks to the upcoming Ford F-150.
With this concept, though, Ford is attempting to show that a mass-produced, lightweight vehicle isn't too far off. This is the Lightweight Concept, and while it may look like a Fusion, it weighs as much as a Fiesta. For reference, the lightest Fusion available to the public is the 3,323-pound, 2.5-liter model with a manual transmission. A manually equipped, 1.6-liter Fiesta, meanwhile, is just 2,537 pounds.