2000 Dodge Stratus Se, Asset # 12666 on 2040-cars

Auto blog

Chrysler killing off the 200 Convertible, Dodge Avenger

When Chrysler rolled out the first-generation 200 to replace the Sebring range in 2010, it included replacements for both the sedan and the convertible. The Sebring Coupe, however, was left out of the mix. And now that the second-generation Chrysler 200 is descending upon us, Auburn Hills is paring things down even further. But this time, it's the convertible that reportedly isn't making the cut. Shame, too, since the rendering above shows what could have been quite an attractive droptop.
As our compatriots at Edmunds point out, sales of the convertible model accounted for less than five percent of overall Chrysler 200 sales, and at those numbers, the considerable cost of engineering a new drop-top couldn't be justified. With the Toyota Camry Solara and Volkswagen Eos also gone from the market (well, the VW isn't gone quite yet), the discontinuation of the Chrysler 200 Convertible leaves the affordable convertible segment largely to the sportier likes of the Ford Mustang and Chevy Camaro and smaller European offerings like the Mini Cooper and VW Beetle.
The Chrysler 200 Convertible isn't the only derivative being left behind with the new model: so too is the Dodge Avenger. That will leave a glaring hole in the Dodge lineup, with nothing to bridge the gap between the compact Dart and the larger Charger. Whether the Dodge brand has any plans to replace the Avenger with another model, not to be based on the 200, remains to be seen.

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Submit your questions for Autoblog Podcast #317 LIVE!

We record Autoblog Podcast #317 tonight, and you can drop us your questions and comments regarding the rest of the week's news via our Q&A module below. Subscribe to the Autoblog Podcast in iTunes if you haven't already done so, and if you want to take it all in live, tune in to our UStream (audio only) channel at 10:00 PM Eastern tonight.
Discussion Topics for Autoblog Podcast Episode #317
Mitsubishi Mirage