2001 Dodge Ram 3500 Van Base Extended Cargo Van 3-door 5.9l on 2040-cars

Auto blog

Chrysler readying Hellcat V8 with Viper-like power

A monstrous supercharged V8 engine could be in store for Chrysler and SRT products, if recent rumors are to be believed. Allpar is reporting that the forced-induction V8 - Chrysler's first, if this goes down - could make its debut this summer.
The story goes that the Hellcat would be based on a 6.2-liter Hemi engine, rather than on the existing 5.7- or 6.4-liter versions of the company's vaunted mill. In any case, the general consensus is that the motor will have gobs of power. Modest estimates call for between 500 to 570 horsepower, with some outliers predicting a figure as high as 600 hp. That figure would put the output would place the Hellcat awfully close to that of the 640-hp V10 in the SRT Viper, too. Allpar contends that a slightly lower powered version would allow Chrysler to keep costs below that of the more powerful Ford Shelby GT500, which might be a sweet spot.
The Hellcat could debut in a number of SRT products. SRT versions of the Charger, Challenger and 300 are all up for grabs, as is the rumored SRT Barracuda.

Dodge Challenger Scat Pack adds power and noise, with a warranty

If you want to go fast, there's certainly nothing wrong with the Dodge Challenger SRT8. With 470 horsepower and 470 pound-feet of torque for 2014, there's certainly not much to complain about. But what if you want something more aftermarket in flavor? There's no shortage of options, but while turning to the tuner world will make your car plenty fast, that extra power won't just shred rear tires, it'll torch your warranty, as well. That's where Dodge's Scat Pack comes in.
With three stages of mods for both the 5.7 and 6.4-liter Hemi V8s Challenger (as well as the 5.7-liter Charger and, soon, the four-pot Dart), the Scat Pack cars give drivers all the power, aggression and noise of a heavily modded aftermarket car while maintaining the piece of mind provided by the Dodge warranty.
Power gets bumped up to 485 horsepower and 475 pound-feet of torque with the 6.4-liter Scat Pack, while the 5.7-liter can provide up to 58 hp and 47 lb-ft of torque to add to the stock engine's 375 horsepower and 410 pound-feet. It's the latter engine that can really get some work done, with upgrades ranging from the mundane - intake and exhaust - to the racy, like the ported heads and high-flow headers.

NHTSA investigating power modules on Chrysler Group SUVs and minivans

The Center for Auto Safety is officially petitioning the National Highway Traffic Safety Administration to begin scrutinizing alleged problems with the totally integrated power module (TIPM) on about 24 Chrysler Group SUVs and minivans. The advocacy group claims that the part's failure can cause affected vehicles to stall or not start at all. NHTSA is still looking into the accusations and deciding whether a full investigation is actually warranted.
The CAS petition claims at least 70 TIPM failures, but according to NHTSA, six of the complaints are for models that don't have the modules. In 34 of the reported cases, the vehicles refused to start, and in 17 of them the engine stalled. There were also two allegations of smoke and one of a fire. However, none of these affected airbag deployment or resulted in a crash.
This petition isn't the first TIPM-related problem for Chrysler Group. A recent report in the New York Times alleged that it found 240 complaints potentially related to the issue on NHTSA's website alone. In September, the automaker also recalled 230,760 examples worldwide (188,723 in the US) of the 2011 Jeep Grand Cherokee and Dodge Durango replace the fuel pump relay circuit inside of the TIPM-7 with one external to the unit. The original part could allegedly cause the models to stall without warning. Even earlier, the company also recalled about 80,000 examples of the Jeep Wrangler and Dodge Nitro in 2007 to have the module reprogrammed.