1975 Dodge 4x4 Classic Mopar Rat Rod Shop Truck on 2040-cars

Auto blog

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Indications of 825 hp and emissions issues for Hellcat called 'speculation' by Chrysler

The 2015 Dodge Challenger SRT Hellcat is probably one of the hottest cars of the moment mostly because of its insane, 707-horsepower supercharged V8. However, there are conflicting reports coming out that the powerplant might be having problems with its emissions compliance and may be capable of even more power.
Jalopnik says that an unnamed source within Fiat Chrysler Automobiles told it that the Hellcat was having problems meeting emissions standards at its 707-horsepower tune. The person claimed that the automaker has been testing the V8 with different types of sensors, possibly to make it a bit cleaner in the future. Autoblog spoke to SRT spokesperson Dan Reid, and he said about the claimed poor emissions, "It's totally speculation."
The source also claimed that the Hellcat had been dynoed at a monumental 825 horsepower, internally. Based on the other rumor, though, it's hard to imagine the engine being emissions compliant like that. Autoblog also asked Reid about this speculation about more power and was told, "They are totally speculating about that."

Chrysler investing $20M in Toledo plant to support 9-speed auto production

In 2011, Chrysler announced a $72-million investment in its Toledo Machining Plant to modernize production of the eight- and nine-speed torque-converters for automatic transmissions made there. That upgrade work won't be finished until Q3 of this year, but Chrysler has already announced a further $19.6-million investment to increase production capacity for the nine-speeders.
The extra units will be necessary because the nine-speed transmission they'll be mated to is going into three popular models: it will debut on the 2014 Jeep Cherokee, then go into the Chrysler 200 and Dodge Dart. The company predicted that this year alone it would sell 200,000 units equipped with the nine-speed tranny, and it is spending some $374 million in addition to the investment in Toledo to upgrade production capacity for it.
The work attached to this new investment won't begin until Q3 of 2014, and it will be finished by the end of that year. There's a press release below with all the details.