Find or Sell Used Cars, Trucks, and SUVs in USA

1962 Dodge Polara 500 -retired Vintage Race Car With A Max Wedge on 2040-cars

US $37,000.00
Year:1962 Mileage:2300 Color: Red /
 red&black
Location:

Glen Cove, New York, United States

Glen Cove, New York, United States
Transmission:727 push button
Body Type:Coupe
Engine:max wedge 440
Vehicle Title:Clear
Fuel Type:Gasoline
For Sale By:Private Seller
Condition:
Used: A vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections. ...
Year
: 1962
Number of Cylinders: 8
Make: Dodge
Model: Dart
Drive Type: push button
Mileage: 2,300
Exterior Color: Red
Warranty: none
Interior Color: red&black
Trim: 500

ENGINE:

64-Stage III 518 Max Wedge 6 bolt heads refurbished by S&K Speed -1963 aluminum cross ram intake manifold-- Two 750 cfm Edelbrock carbs- 

New hyd. Comp cam kit XE284H  507 / 510 lift- 284--296 duration- lifters -springs -push rods -timing chain -roller rockers-shafts- 

440 short block Professionally rebuilt by S&S -bored 40 over -new pistons- steel crank -balanced- high volume Hemi oil pump- 2300 miles on motor - used only for local cruise nights and shows-

9-1/2+:1 compression- runs on 93 pump gas. 

Oil pressure 65-80 lbs -Water temp 180-doesn’t overheat. New mini starter- alternator- water pump -recored 26” radiator- fuel pressure gage


TRANSMISSION: 727- push button on dash - Cheetah reverse full manual valve body - 10” Dynamic 3000? stall speed converter (works great)


EXHAUST: Doug Thorley Headers -stage 8 locking bolts-Full length 3” Flowmaster Delta series exhaust system custom fabricated by Kooks - Flowmaster #44 mufflers (sounds awesome loud )


WHEELS: Front -15 x 5-1/2 steel Mopar -tires 205-70-15. Rear- 15 x 10 steel Mopar custom made by Stockton Wheel - MT tires L60 15


ELECTRONICS: Electronic ignition- MSD box-Autometer tach and gauges - Electric fuel pump, Painless fused switch panel & wiring - electronic battery disconnect dash controlled 

(also out back)- new voltage reg.& alt. red top battery


REAR: 8- 3/4- Sure grip-3:91 a stronger #489 with 1-7/8 pinion with Strange gears & axels- you can remove these drums without the special tools and rivets-  (has a snubber)New shocks  

DRIVESHAFT: 1 piece custom made balanced by Nassau Driveshaft


BODY/ FRAME: Frame connectors- tow bar tabs- 4-point roll cage- no rear seat- Mini tubs with Super Stock Springs moved in to frame- to fit larger tires.New shocks. Shumaker torque control 

bracket welded to frame, new steering column bushing. Drum brakes with new shoes- cylinders -wheel bearings- -dual master cylinder 


INTERIOR: Refurbished dash, steering wheel- door panels and rear 1/4 panels--New headliner- carpets and rear panels - New gas & brake pedals- New SoftSeal. door, window, trunk, and hood seals--all original glass- 

The original instrument panel read 56,000. I replaced it with one in much better condition that now reads 29,000+


EXTERIOR: See photos -Painted 4 years ago - no dents -dings -chips- Re-chromed front & rear bumpers. Check out the hard to get plastic parking/signal lenses front and rear.

 An original 62 max wedge hood with scoop and holes added for velocity stacks. Detailed engine - trunk -all chrome and stainless is original in good condition.

I spent much $$$$ on ebay looking to upgrade pieces when I could find them.


Although not an original Max wedge this car has a history of being a max wedge race car most of it’s previous life, the former 2 owners never registered it. 

I bought this car 9 years ago. I decided to do a conservation on it, doing everything necessary while still keeping the old school raced-bred appearance. The last 9 years  have been a labor of love, time and money well spent on refurbishing the exterior , interior mechanicals. engine and trim pieces, to get it to where it is today.

Today it is what it is, a retired race car that’s used  for local cruise nights and car shows.


It had a 1966 426- block in it when I bought it but after a few years it froze a rod bearing -that’s when I was told it also had a cracked crank I decided it made more sense to replace it with a professionally rebuilt 440 short block that could runs on pump gas and and add some cubic inches. While it was apart I had the stage III 518 max heads re-done by S&K speed and ordered a new comp cam, lifters, roller rockers, push rods, springs, shafts. 

$$$$ later it runs great (pictures of heads and block before assembly included)


It starts every time, it’s loud. It has a strong stable idle (about 1000 rpm), it doesn’t stall.

Shifts easy just push 1-2-3- 

It’s great around town. (it’s a piece of theater ) It’s reliable and it’s faster than it needs to be

It’s gets more than it’s share of attention at cruise nights and car shows.


Head lights, low & high beam, tail lights, parking & backup lights, signals, horn, wipers, dash lights, dome light, speedometer/odometer, temp gauge, voltage gauge, oil pressure gauge--all work.


What doesnt work:

the clock---the radio -no speakers are hooked up to it (it’s too loud anyway)---choke-there are no chokes in the 750 edelbrock carbs (more air)---emergency brake- not hooked up ( less drag) use Park


$500 pay pal deposit is required from auction winner.

Electronic transfer, cashiers-check or cash required for balance of payment within 8 business days of the end of auction..

Buyer is responsible for transportation.

This is an auction there are no guarantees or returns so please make sure that this is what you want before you bid.  

I have taken the time to carefully describe this car and include a substantial number of photos. However, it is very important to keep in mind that it is pre-owned, not brand new.  

After carefully reading the entire description, rather than making a potentially incorrect assumption if any statement or comment is unclear, or if you have questions, please e-mail me prior to bidding.





Auto Services in New York

Vogel`s Collision ★★★★★

Auto Repair & Service, Automobile Body Repairing & Painting, Auto Oil & Lube
Address: 100 N Winton Rd, Ontario-Center
Phone: (585) 482-9655

Vinnies Truck & Auto Service ★★★★★

Auto Repair & Service
Address: 451 Windsor Pl, East-Rockaway
Phone: (929) 224-0634

Triangle Auto Repair ★★★★★

Auto Repair & Service, Engine Rebuilding & Exchange, Auto Engine Rebuilding
Address: 60 Park Ave, Castleton
Phone: (718) 442-9159

Transmission Giant Inc ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Auto Transmission
Address: 1114 Broadhollow Rd, Glenwood-Landing
Phone: (631) 293-0090

Town Line Auto ★★★★★

Auto Repair & Service
Address: 6501 State Route 32, Berne
Phone: (518) 966-8003

Tony`s Service Center ★★★★★

Auto Repair & Service, Brake Repair, Tire Changing Equipment
Address: 503 Brown St, Evans-Mills
Phone: (315) 639-6300

Auto blog

Dodge Viper recall requires small-handed mechanics

Fri, 25 Apr 2014

It has been over a year since Chrysler first announced its recall of 3,660 2003-2004 Dodge Vipers because the airbag could suddenly deploy. The repairs are finally beginning, and it appears to be a nightmare for mechanics.
According to the automaker's filing with the National Highway Traffic Safety Administration, the airbag control module can fail, which causes the bag or the seatbelt pre-tensioner to deploy without warning. It took over a year to design the new parts, according to The New York Times. However, Chrysler finally has a new "jumper harness with an in-line diode filter circuit" ready to fix the problem.
The dilemma now moves to the mechanics who have to actually install the part. A 47-step guide from Chrysler explains that the procedure should take about two hours. It's not an easy job, though. Most of the dashboard has to be taken apart, and the instructions include this helpful bit of advice: "Installing the jumper harness and filter box into position is not an easy task. Patience, perseverance, and small hands are required." We wish the best of luck to them. The fix comes just in time for the Vipers to enjoy the summer sun.

We cruised Woodward in the 2015 Dodge Challenger SRT Hellcat [w/video]

Tue, 19 Aug 2014



We were definitely rock stars at the 20th edition of the Dream Cruise.
The yell came from somewhere in the crowd: "Hey Hellcat, push it!" We obliged with a jab of the throttle, and the 707 horses of the 2015 Dodge Challenger SRT Hellcat roared to life. It went on like this. All weekend. It's one thing to attend the Woodward Dream Cruise, it's quite another to star in it.

Has Dodge stepped in it again with Scat Pack lawsuit?

Mon, 20 Oct 2014

Lawsuits are an unfortunate part of doing business in just about any industry, so the latest complaint filed by a California-based aftermarket firm against Chrysler would seem to be nothing more than business as usual. But this isn't the first time the two companies have sparred over this particular issue.
According to a report from Automotive News, the dispute revolves around the Scat Pack name that Chrysler first offered on the Charger, Coronet, Dart and Super Bee starting in 1968. Scat Enterprises, a manufacturer of crankshafts and other components for Dodges and other vehicles, sued Chrysler for using its name. A few years later the Scat Pack disappeared from the Dodge catalog.
Fast forward to August 2013 when Chrysler applied to register the Scat Pack name anew. The US Patent and Trademark Office turned down Chrysler's application, but the automaker proceeded anyway, unveiling new Scat Packs for the Challenger, Charger and Dart at last year's SEMA show.