1969 Dodge Superbee 512 Cubic Inch Stroker 525 H.p. on 2040-cars

Auto blog

Dodge Challenger Scat Pack adds power and noise, with a warranty

If you want to go fast, there's certainly nothing wrong with the Dodge Challenger SRT8. With 470 horsepower and 470 pound-feet of torque for 2014, there's certainly not much to complain about. But what if you want something more aftermarket in flavor? There's no shortage of options, but while turning to the tuner world will make your car plenty fast, that extra power won't just shred rear tires, it'll torch your warranty, as well. That's where Dodge's Scat Pack comes in.
With three stages of mods for both the 5.7 and 6.4-liter Hemi V8s Challenger (as well as the 5.7-liter Charger and, soon, the four-pot Dart), the Scat Pack cars give drivers all the power, aggression and noise of a heavily modded aftermarket car while maintaining the piece of mind provided by the Dodge warranty.
Power gets bumped up to 485 horsepower and 475 pound-feet of torque with the 6.4-liter Scat Pack, while the 5.7-liter can provide up to 58 hp and 47 lb-ft of torque to add to the stock engine's 375 horsepower and 410 pound-feet. It's the latter engine that can really get some work done, with upgrades ranging from the mundane - intake and exhaust - to the racy, like the ported heads and high-flow headers.

2015 Dodge Charger SRT Hellcat revealed [UPDATE]

Almost immediately after we drove the 2015 Dodge Challenger SRT Hellcat, we began wondering: what's next? Pumping 707 horsepower into the Challenger seemed so crazy - and so intoxicating - we just assumed that Dodge would try that trick again.
Rumors swirled about a Charger Hellcat. Frankly it makes even more sense than the Challenger version. The Charger is a bigger car, and Dodge has never been shy about dropping monster engines under its hood. Hell (cat), we've seen Charger mules running around town that appeared to be the super sedan.
And finally, it's here. The 2015 Dodge Charger SRT Hellcat was revealed today at a preview event near Detroit, and it will be a centerpiece of the Chrysler display this weekend at the Woodward Dream Cruise.

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.