2010 Dodge Challenger 2dr Cpe Se Power Drivers Seat Tire Pressure Monitor on 2040-cars

Auto blog

2013 Dodge Challenger V6 recalled for fire risk, owners asked not to drive

Chrysler has issued a recall for the V6 version of the 2013 Dodge Challenger (as pictured above in 2012MY) over the possibility of a wiring harness that could short circuit and lead to a fire. Owners of these V6 Challengers built from November 2012 through January 2013 are being urged to contact dealers immediately and, in the meantime, not to drive their cars or park in or near any buildings.
Chrysler estimates around 2,500 potentially affected Challengers are in owners' hands, while another 1,900 are still sitting on dealer lots. The total number of recalled vehicles is 4,459.
So far, Chrysler says that seven fires have been reported - none resulting in injuries. The company is instructing vehicle owners to contact their dealer to find out if their vehicle is included in the recall, but owners can also find the build date information of their vehicle by checking the label in the driver's door jamb.

Dodge Viper recall requires small-handed mechanics

It has been over a year since Chrysler first announced its recall of 3,660 2003-2004 Dodge Vipers because the airbag could suddenly deploy. The repairs are finally beginning, and it appears to be a nightmare for mechanics.
According to the automaker's filing with the National Highway Traffic Safety Administration, the airbag control module can fail, which causes the bag or the seatbelt pre-tensioner to deploy without warning. It took over a year to design the new parts, according to The New York Times. However, Chrysler finally has a new "jumper harness with an in-line diode filter circuit" ready to fix the problem.
The dilemma now moves to the mechanics who have to actually install the part. A 47-step guide from Chrysler explains that the procedure should take about two hours. It's not an easy job, though. Most of the dashboard has to be taken apart, and the instructions include this helpful bit of advice: "Installing the jumper harness and filter box into position is not an easy task. Patience, perseverance, and small hands are required." We wish the best of luck to them. The fix comes just in time for the Vipers to enjoy the summer sun.

2015 Dodge Charger Pursuit prepares to keep Hellcats in line

Earlier today, Dodge pulled the wraps off its 2015 Charger SRT Hellcat - a 707-horsepower sedan capable of sprinting to 60 miles per hour in 3.7 seconds and reaching a top speed of 204 mph. Naturally, the car debuted in a bright shade of pull-me-over red, so it was fitting, then, that Dodge also brought its newly updated 2015 Charger Pursuit to keep everything under control.
No, cops won't be able to spec their Charger cruisers with the 707-hp Hellcat engine (oh man, imagine the chase scenes...), but law enforcement officials will be able to choose from either a 3.6-liter V6 or 5.7-liter Hemi V8, producing 292 hp and 370 hp, respectively. V8 models can be ordered with all-wheel drive, and Dodge estimates that with either engine, the Charger Pursuit can achieve up to 26 miles per gallon on the highway (thanks to the V8's four-cylinder mode).
Other updates for 2015 include improved braking power, a seven-inch display in the instrument cluster, a five-inch display in the center stack, and a new vehicle systems interface that could make it easier for police squads to install computer and radio equipment.