Sliding Door Factory Warranty Rear A/c Back Up Camera Off Lease Only on 2040-cars

Auto blog

Chrysler 200 prototype spied for first time with new body

Chrysler is deep into testing for its next-generation 200 sedan, a new model that is utterly essential to the brand's continued health. The next iteration is tasked with wiping away anything reminiscent of the Sebring, which the current 200 is still based on. According to our spy, this is one of the first of the new 200s to wear a production body rather than the Alfa Romeo Giulietta-based mules that are thick on the ground in Auburn Hills.
Immediately apparent is that the new 200 ditches the awkwardly styled C-pillar that's typified four-door 200 sedans (and Sebrings before them) for years. The new, sleeker roofline is almost more of a four-door coupe than a traditional sedan, which hints that this new car will try to be more fashion-forward than its predecessor. The rear deck is set off by a sporty decklid spoiler, while a set of staggered rectangular exhaust pipes poke out of the bumper.
The front end appears sleeker, and we'd be lying if we didn't spy a bit of Dart through the camouflage, particularly with the headlights. A large, gaping lower air intake is visible, although our spy seems to think it'll shrink before production models debut. Whatever the new 200 ends up looking like, we expect to see a lot more of its styling from Chrysler in the coming years.

Ford and Chrysler reducing summer plant shutdowns

Most domestic automaker assembly plants traditionally take a couple of weeks off during the summer. The shutdowns give each plant time for much needed repairs and maintenance, and in some cases, help better align production with demand. Not this year, though, as demand for many models is outstripping what Ford, Chrysler and General Motors plants can produce.
Ford has announced that it will shorten its annual summer shutdown for most North American plants from two weeks to one. The shorter shutdown will increase the carmaker's annual North American production by 40,000 units on top of the 200,000 extra units that it was already planning to produce this year versus last. Automotive News reports that Ford produced 2.8 million vehicles on this continent in 2012, and that output this year has already increased 13 percent through April.
Chrysler, meanwhile, is also operating at full tilt and plans to run some plants through the summer with no shutdown at all. Those not getting a break include Jefferson North where the Jeep Grand Cherokee and Dodge Durango are assembled, Toledo North that will assemble the new Cherokee, and Conner Avenue, home of SRT Viper production. Other assembly plants will be down for a single week, while all of Chrysler's engine and transmission plants except one in Indiana will continue operating with no shutdown this summer.

Chrysler recalling 382k Ram HD diesel pickups, 184k SUVs

Between GM's ignition switches and Takata's airbags, it's been a big year for recalls, but they keep rolling in. The latest comes from Chrysler, which has announced a pair of recalls for certain heavy-duty pickups and SUVs.
The first issue revolves around the 6.7-liter Cummins diesel engine available in the 2010-2014 Ram HD trucks, including 2500 and 3500 series pickups as well as 4500 and 5500 series chassis cabs. In the affected units, "a terminal connector near the fuel heater may be subject to friction-induced corrosion," according to the first of the two announcements from Chrysler below.
The problem could result in overheating and fuel leakage. Chrysler launched its investigation following cases of overheating, none of which actually started a fire, much less an injury or accident. As a precautionary measure, however, Chrysler is instructing service technicians to replace the terminals on an estimated 381,876 Ram units around the world - the vast majority of those (314,704) registered in the US, another 59,432 in Canada, 1,803 in Mexico and 5,937 abroad.