Find or Sell Used Cars, Trucks, and SUVs in USA

1953 Chevrolet 3100 5 Window Truck Pickup Rat Rod on 2040-cars

US $23,500.00
Year:1953 Mileage:300
Location:

Marion, Ohio, United States

Marion, Ohio, United States

 Thank you for looking at my auction! Up for sale is a well built 1953 Chevrolet 5 Window Pickup. The truck was built by our shop in Marion, Oh called Poor Boys Resto. You can check us out on facebook. We are a local shop who builds hot rods and customs, does full restorations, and Custom race car work. We have an owned an operated Top Sportsman drag racing team, and bring to the table 40 years of combined experience between my father and I. This truck was a project that we built to keep as our own shop truck. Looking to put more money into our car as the season draws mid-way. So the truck is up for Sale As-is. The best components and the utmost attention to detail were mandatory on this vehicle. The details on the build are below. Any questions please do not hesitate to call me at 740-262-3732

Engine- 5.3l Ls, New wires, plugs, wire heat boots, starter, and alternator. Engine and alternator was mounted using Dirty Dingo slider mounts and the Alt only set up. 60,000 MILES!!!

Trans- 4l60E, 30" Lokar Trans mounted shifter. 

Drive TrainNew balanced custom driveshaft with new yoke and U-Joints built by Driveline 1 out of Columbus, OH. 75' Camaro GM 10 bolt 8.5 Rear end, Non-Posi, Drum Brakes.

Chassis- Factory chassis retained. Mustang II front suspension out of a mid 70's mustang. Front big disc brake kit. 11.5" drilled and slotted rotors with GM metric calipers.  Chassis was POR-15 painted. Boxed in the front where the IFS was installed. Brake lines are all stainless steel other than the tough bends and those are the NiCopp line. New chassis mounted power brake booster and master cylinder. Has a MANUAL mustang II rack. New Borgeson joints and stainless steel shaft were used as connections. Jegs 20 circuit wiring harness powers the chassis and inner cab. All lights are functional and new.
Truck Sits where it does because I like to drive things and not avoid railroad tracks or high bumps.  It lays running boards out in the grass and sits about 2" off the ground otherwise. Truck was built for functionality not to be a trailer queen. If that's the route you want to go you can adjust the front bag cups, and i will include a rear step notch kit, made for this frame from Gambino customs bought here on ebay.

Exhaust
- Hooker Block Hugger Headers, 2.25 single Custom built exhaust with a Flowmaster 40 Series muffler.

Air-Ride- The Air-Ride System is 100% RideTech other than the rear bags and mounts. Installed the RideTech front mustang II bag brackets, bags, and shock kit. Has the upgraded kit that comes with a larger rear tank, 2 compressors, and the red billet valve assembly which is mounted behind the seat. The rear set up is Slam Specialties 7" bags for a much nicer ride, paired up with Thor Brothers brackets.

Fuel System- Tanks Inc fuel injection tank. Bought the pump that is capable of handling 600hp. (We were going to run turbos on it.) The fuel System is 100% 6an braided line. Has the Corvette regulator system which is the return/filter/regulator all in one little tube.

InteriorThe dash was painted black with the polished glove box and radio cover. Factory re-covered and Fully re-built seat. All factory trim is in place and functional. It still needs carpeted, gauges, and the door glass put in. *You must purchase glass* Used the truck on nice days so never worried about it. Has a new chrome tilt column, a a new grant steering wheel. The turn signal and hazards are built into the column. Has factory door panels that i have not installed. Truck comes with another set of door that have all door and inner workings in it. You will need DOOR GLASS. All other glass in the truck was replaced with new seals.

Exterior- The truck was painted about 20 years and shows it with the beautiful patina it has. Has some bondo in the lower rear fenders, and front lower front fenders. That tail gate has quite a bit of bondo too. Not because of rust but i think because they were trying to smooth the lines out. The cab was purchased from kansas and has a few dents but ABSOLUTELY ZERO RUST. Bought a fulton visor to go along with it. Bed is not finished in the pictures but will be by auction end. Its getting red-oak to enclose the tank and Air-ride. There is absolutely zero room to work with using the factory chassis so instead of raising the bed floor 6-8 inches like an s-10 build i placed the tank near the cab for easy fill-ups and you will still have 4 1/2 foot of whole depth bed to use for parts, chairs, coolers, and etc.. You will have 8 bolts to take out for any air-ride service or fuel system problems. *Keeping it functional* especially for those without a lift.

Wheels- Wheels are Boss 338 18x8 front and 18x9.5 rear. These are wrapped in new Nitto Neo Gen tires. Rears have a nice dish to them and give it that hot rod look.




                           




On Jun-24-14 at 04:55:31 PDT, seller added the following information:

 I would do some trading on a 1967-1969 Camaro, or a 1967-1973 firebird. Thanks!

Auto Services in Ohio

Zink`s Body Shop ★★★★★

Automobile Body Repairing & Painting
Address: 33609 Till Rd, Bremen
Phone: (740) 385-7448

XTOWN PERFORMANCE ★★★★★

Automobile Parts & Supplies, Automobile Accessories, Lifts-Automotive & Truck
Address: 1790 West Park Square, Wilberforce
Phone: (937) 372-1324

Wooster Auto Service ★★★★★

Auto Repair & Service, Used Car Dealers
Address: 3255 E Lincoln Way, Mount-Hope
Phone: (330) 263-1110

Walker Toyota Scion Mitsubishi Powersports ★★★★★

New Car Dealers, Used Car Dealers, Motorcycle Dealers
Address: 8457 Springboro Pike, Springboro
Phone: (937) 433-4950

V&S Auto Service ★★★★★

Auto Repair & Service, Brake Repair
Address: 712 Wales Rd NE, Beach-City
Phone: (330) 837-9180

True Quality Collision ★★★★★

Automobile Body Repairing & Painting
Address: 6192 Webster ST, Yellow-Springs
Phone: (937) 264-1234

Auto blog

Callaway debuts its new C7 Stingray at National Corvette Museum

Fri, 02 May 2014

Callaway showed off its first tuned version of the 2014 Corvette Stingray at the National Corvette Museum last week, giving the rampant enthusiasts of America's sports car a look at the roughly 620-horsepower, supercharged rocket.
Unlike the Corvette SC610 we showed you back in January, this Stingray packs a fair bit more oomph. Horsepower is only up ten ponies, but torque has jumped from 556 pound-feet to "at least" 600 pound-feet. Neither horsepower nor torque is official quite yet, although Callaway is expecting to know just what its creation can do once testing and validation is completed later this month.
The 6.2-liter, supercharged V8 now boasts a new, three-element intercooler, which Callaway claims only allowed the inlet air temperature to increase by ten degrees Fahrenheit during dyno runs. Previous designs saw a 35-degree-Fahrenheit jump. The exhaust system has also been fettled with, and now is even less restrictive.

Next Corvette ZR1 to get 700 horsepower?

Tue, 19 Feb 2013

Word has it General Motors may offer as much as 700 horsepower in the C7 Corvette ZR1. Motor Trend reports the next Corvette Z06 will continue to rely on its naturally aspirated 7.0-liter V8 engine for thrust, but the lump will deliver substantially more power. How much more? MT says the engine could deliver up to 600 ponies. That's a jump of 95 horsepower over the current Z06, though no figures have been finalized as of yet. Right now, GM is reportedly waiting to see what sort of grunt it can glean from the next ZR1.
The automaker has already made it clear it will resurrect the LT5 name for the new supercharged V8, and if GM is already pulling 600 from the Z06, the big dog ZR1 would theoretically offer 700 horsepower. Either way, the range-topping Corvette will be suitably insulated from its less potent siblings. Stay tuned. We aren't likely to see the Z06 for at least a year, with the ZR1 trailing along at some point there after.

2014 Chevrolet Cruze TD fires up its new diesel motor

Thu, 07 Feb 2013

Ever since General Motors confirmed plans to produce a diesel-powered Cruze back in 2011, we've been eagerly awaiting its arrival. And as part of the 2013 Chicago Auto Show, Chevrolet has pulled back the cover on its oil-burning compact sedan, set to go on sale in the near future with a starting price of $25,695, not including $810 for destination.
The heart and soul of the Cruze TD (that's its official name) is a 2.0-liter turbo-diesel inline four-cylinder engine rated at 148 horsepower and 258 pound-feet of torque, mated solely to a six-speed automatic transmission. The engine also has an overboost function that will increase torque to 280 lb-ft for up to ten seconds. The full brace of official specs haven't been released, but GM tells us that highway fuel economy will come in at 42 miles per gallon. If that number sounds familiar, it's because the Volkswagen Jetta TDI has the exact same rating. Unlike the Jetta, however, the Cruze TD can run on B20 biodiesel, where as the Volkswagen can only accept B5.
Model-specific changes to this 2014 Cruze TD include an aero kit and unique 17-inch alloy wheels. Inside, there's a full leather interior, and Chevrolet will provide two years of complimentary scheduled maintenance, not to mention a 100,000-mile powertrain warranty.