12 Passenger, Rear Air/heat, 6.0l Gas V8, Abs, Rubber Floor Mats, Trades? on 2040-cars

Auto blog

Camaro spy shots show subtly different grille, front fascia

It looks like there some changes in store for the Chevrolet Camaro - the only thing is that we just don't know what Chevy has up its sleeve. Looking at these spy shots, we'd initially be inclined to think that there is just a minor facelift or a new special edition, but upon closer inspection, there are a few oddities about this car that definitely have us intrigued.
The most obvious difference on this prototype is the slightly restyled front fascia with a smaller lower air inlet and the two-bar grille. Then we get to some of the car's mysterious details. For starters, this fascia has the SS vent above the grille, but it looks to be blocked off. Granted this could just be a one-off piece used for testing. What really piqued our interest was at the rear of the car where it has quad exhaust outlets that are used on the ZL1. Could this be the LS7-powered Camaro that we reported on back in December?
At this point, your guess is as good as ours as to what we're looking at here, so let us know in the comments what you think this could be.

GM recalls 8,500 Chevrolet Malibu models for rear suspension glitch

According to a letter from General Motors to the National Highway Traffic Safety Administration, flaws in the build process of the 2013 Chevrolet Malibu have led to the recall of 8,519 cars. Units built between December 6, 2011 and January 15, 2013 may have been assembled with rear suspension cradles that had insufficient torque applied to certain bolts. That out-of-spec assembly could lead to issues ranging from slight noises to a loss of vehicle control.
The problem was first noticed in December of last year by a GM test fleet driver and eventually tracked back to the improperly torqued bolts on the suspension cradle assembled through July 2012 by a supplier located not too far from the Malibu's Detroit/Hamtramck Assembly Plant. Since an official NHTSA recall notice has not been issued yet, it isn't clear whether or not Detroit-built Malibus were the only ones affected (the 2013 Malibu is also built at GM's Fairfax Assembly Plant in Kansas City, Kansas). Dealers will fix the problem by inspecting vehicles for proper torque specs, retightening if not within specs and, in some cases, perform a rear-wheel alignment.

2014 Chevrolet Silverado tows in new configurator, microsite

Judging by your continued enthusiastic response to configurator notices, dear reader, you enjoy speccing out new cars as much as we do. Better still, there tends to be even more ways to personalize, configure and bloat theoretical MSRPs on full-size trucks as there are with more ordinary passenger cars. In addition to trim level, engine and transmission choices, truck buyers usually have to specify items like cab configuration, bed length, number of driven axles, tow packages, gear ratios and all sorts of bits and bobs.
That's why we're pleased to see the DIY specification utility for the 2014 Chevrolet Silverado come alive so soon after this week's Detroit Auto Show debut. While the configurator lacks pricing (General Motors hasn't announced numbers yet) and full options, you can still spec out your half-ton rig, and even print it out or email it to your friends. Beyond the configurator, the new model-specific site is pretty cool, too, with various videos and closer looks at the truck's new features.
The new Chevrolet pickup range won't be on dealer lots until sometime this summer, so whether you're a building contractor, an avid sportsman or just a guy or gal that loves full-size trucks, you might want to check out the link below to keep your appetite whetted. If you're more of a Sierra fan, well, it looks like you're going to have to wait a while - GMC hasn't updated its site yet.