1986 Chevrolet Corvette on 2040-cars

Auto blog

Veyron and C7 Corvette join cast of Transformers 4

Like the Fast & Furious franchise, the Michael Bay-directed series of Transformers movies has become known as much for its bad acting as its impressive lineup of cars. As filming just started for Transformers 4, Bay's website has confirmed two new cars for the next installment as well as a makeover for everyone's favorite tractor trailer hero, Optimus Prime.
Joining the cast of T4 are a "race-inspired" Chevrolet Corvette Stingray and a Bugatti Veyron Grand Sport Vitesse. While Bay's website did not supply names for either car, Bugatti is reporting on its Facebook page that the Veyron will join the Autobots. Speaking of the good guys, top Autobot Optimus Prime is getting an all-new body based on a Western Star with a gaudy appearance that was seemingly inspired by Trick My Truck - right down to the six smoke stacks and side pipes!

This is your 2014 Chevrolet SS

Think you've waited long enough for this? If so, then you'll want to savor the high-res photos we've so far been given of the 2014 Chevrolet SS, the first rear-wheel-drive performance sedan from The Bowtie in 17 years.
We all know its our version of the brand new VF-model Holden Commodore, but what's under the hood that earns the appellation "performance?" A 6.2-liter LS3 V8 engine producing 415 horsepower and 415 pound-feet of torque. That's 35 hp and lb-ft less than the same engine is expected to produce in the 2014 Chevrolet Corvette. Chevrolet says the sedan will get from 0-to-60 miles per hour "in about five seconds."
Shifting comes courtesy of a six-speed automatic with paddles on the steering wheel, while stopping arrive via four-piston Brembo calipers up front, a single sliding piston in back. The forged aluminum wheels are 19-inchers all around, each set supporting right around 50 percent of the sedan's weight, and the aluminum hood and trunk are meant to keep the center of gravity low.

GM recalls 8,500 Chevrolet Malibu models for rear suspension glitch

According to a letter from General Motors to the National Highway Traffic Safety Administration, flaws in the build process of the 2013 Chevrolet Malibu have led to the recall of 8,519 cars. Units built between December 6, 2011 and January 15, 2013 may have been assembled with rear suspension cradles that had insufficient torque applied to certain bolts. That out-of-spec assembly could lead to issues ranging from slight noises to a loss of vehicle control.
The problem was first noticed in December of last year by a GM test fleet driver and eventually tracked back to the improperly torqued bolts on the suspension cradle assembled through July 2012 by a supplier located not too far from the Malibu's Detroit/Hamtramck Assembly Plant. Since an official NHTSA recall notice has not been issued yet, it isn't clear whether or not Detroit-built Malibus were the only ones affected (the 2013 Malibu is also built at GM's Fairfax Assembly Plant in Kansas City, Kansas). Dealers will fix the problem by inspecting vehicles for proper torque specs, retightening if not within specs and, in some cases, perform a rear-wheel alignment.