1964 Chevrolet Corvette Coupe on 2040-cars

Auto blog

Mother's Day Suggestion No. 2,506

With Mother's Day coming up, we're always looking for new gift ideas to celebrate the occasion, but hot laps around a track might not be the best suggestion for Darius Khashabi. In a video posted on YouTube, Khashabi straps his mom into the passenger seat of his C6 Corvette Z06 for some laps around Sonoma Raceway (formerly Infineon Raceway) at "60 percent" with comical results.
Now this isn't the first time Mama Khashabi has gotten seat time in her son's car around a track, as his YouTube page shows him pulling a similar stunt - with similar results - around Mazda Raceway Laguna Seca last year. Scroll down for the video, but know that the action really gets going at around the 1:40 mark.

C7 Corvette turbo with 1,000 horsepower promised from Hennessey

If you can't wait for the next-generation Chevrolet Corvette ZR1, Hennessey says they will have you covered. The Texas-based company has announced it will offer a spate of upgrades for the 2014 Corvette ranging from a range of bolt-on options all the way up to a 1,000-horsepower, twin-turbo system. Buyers can start with a cold air intake, cat-back exhaust or stainless steel long-tube headers, but Hennessey says it will also offer up three stages of forced induction mayhem should those bits and baubles not provide enough thrust.
Those choices start with a supercharger system good for up to 700 hp, though Hennessey will gladly ditch the blower in favor of two turbos. Doing so will spin the crank to the tune of 800 horsepower all the way up to a certifiably ludicrous 1,000 ponies. There's no word on how much these tricks will cost you - or when they will be available, as we're guessing they haven't gotten their hands on the car yet - but you can head over to the Hennessey site to drop them a line if you're curious.

GM recalls 8,500 Chevrolet Malibu models for rear suspension glitch

According to a letter from General Motors to the National Highway Traffic Safety Administration, flaws in the build process of the 2013 Chevrolet Malibu have led to the recall of 8,519 cars. Units built between December 6, 2011 and January 15, 2013 may have been assembled with rear suspension cradles that had insufficient torque applied to certain bolts. That out-of-spec assembly could lead to issues ranging from slight noises to a loss of vehicle control.
The problem was first noticed in December of last year by a GM test fleet driver and eventually tracked back to the improperly torqued bolts on the suspension cradle assembled through July 2012 by a supplier located not too far from the Malibu's Detroit/Hamtramck Assembly Plant. Since an official NHTSA recall notice has not been issued yet, it isn't clear whether or not Detroit-built Malibus were the only ones affected (the 2013 Malibu is also built at GM's Fairfax Assembly Plant in Kansas City, Kansas). Dealers will fix the problem by inspecting vehicles for proper torque specs, retightening if not within specs and, in some cases, perform a rear-wheel alignment.