1963 Chevrolet Corvette on 2040-cars

Details: 1963 VIN 115968, May build, 327/340hp, Silver Blue, dark blue interior, replacement 1964 block. Owned for 2.5 years; did not get any substantial history on the car but it was delivered new in Florida. Everything on this car has been touched except the paint! I wanted to do this car to a high level of correct technical and mechanical detail not worrying about the paint or driving it around. All that is left to do on this car to make it an overall high quality restoration is the paint.YOU CAN'T BUY ANY OTHER ENTRY LEVEL CAR AND DO ALL THE THINGS THAT HAVE BEEN DONE TO THIS CAR WITHOUT BEING WAY OVER MY ASKING PRICE.. The paint is very correct from a color and metallic size standpoint. It has a number of scratches and small door chips as well as shows age in the tiny spider cracking. It�s a decent 20-footer if you will 2. I have some of the best original hubcaps you will find anywhere. Drivetrain/frame/mechanics 1. Original rear spring was replaced with new correct Eaton unit, kept original. Ride height is perfect. 2. Original 4:11, correct dated, gear was replaced with a new 3:36 gear and a new Eaton posi unit 3. Original trailing arms were replaced with new units with all new bearings etc. 4. The supporting member that the pumpkin bolts to, that attaches to the sombrero�s was replaced. 5. One of the half shafts was replaced as well as all new u-joints everywhere. 6. Drive shaft balanced with new u-joints 7. Number 4 frame member was replaced with a new OEM unit and welded into place. 8. The rest of the frame has some rust but is serviceable and safe and has been looked at by multiple mechanic. IT IS SOLID 9. Original transmission (Muncie) with correct dates and VIN stamp was completely rebuilt and a new wide ratio gear installed to mate to the 3:36 rear end. 10. New Luk clutch was installed along with new correct 63 fork, throw out bearing and thrust bushing. 11. The engine block is an 870 correct casting block but is NOT dated correctly (DEC 64). I did a complete rebuild of the engine and found that most all the 340HP parts were correctly dated for the May build. The windage tray looked like the original lost a rod and that is why there is a replacement block. All engine parts were of good quality and documented, eagle rods, TRW pistons, crank turned .010 etc etc. Correct 609 water pump, carb, distributor (by Lars) etc etc. rebuilt Alt which is not correct but I have correct core that goes with the car. I restored the engine compartment to as close to factory as I could. New exhaust manifolds (2.5�) and all parts restored to high level of accuracy and appearance. Carb done to correct show factory condition. Used flat pistons for 10-1 CR and used stock 300HP cam and hydraulic lifters. Original balancer a restored by Damper Doctor. New fan clutch. 12. I took the liberty with adding the Borgeson power steering unit and pump. I have the original steering gear and in fine shape. Worth every cent! 13. The entire brake system has been checked and any issues were addressed. All drums in excellent shape and had been freshly turned. Pads in fine shape. Replaced rear hydraulic units and adjusted. Brand new GM correct replacement Master cylinder. Brakes function excellent. Emergency brake functions as well. 14. New aluminized exhaust system from corvette Central with the N-11 mufflers (welded). New tips and all hangers etc and new heat riser unit. 15.