Rear Bed Cover Front Bucket Seats Power Seat Low Miles One Owner on 2040-cars

Auto blog

Indian tuner turns Chevy Optra into Mustang 'Eleanor' replica

If you are a big fan of automotive oddities, this may come as a little treat. If you are a Shelby or Mustang diehard, prepare to have your sensibilities violated.
The master fabricators at BigDaddyCustoms are the minds behind what you see above. At first, it appears to be a slightly misshapen custom Mustang, modeled after "Eleanor" from Gone In 60 Seconds, but upon further examination, something appears to be amiss. In fact, the custom shop, based in India, has created an Eleanor replica grafted upon a lowly Chevrolet Optra. While it may take a second for the Optra to ring a bell, you should recognize its badge-engineered sibling, the Daewoo Lacetti, used on Top Gear.
We don't know what star would opt for the Reasonably Priced Car in Shelby's clothing, but it's clearly someone more concerned with the aesthetic than the performance credentials of this automotive mash-up.

GM recalls 8,500 Chevrolet Malibu models for rear suspension glitch

According to a letter from General Motors to the National Highway Traffic Safety Administration, flaws in the build process of the 2013 Chevrolet Malibu have led to the recall of 8,519 cars. Units built between December 6, 2011 and January 15, 2013 may have been assembled with rear suspension cradles that had insufficient torque applied to certain bolts. That out-of-spec assembly could lead to issues ranging from slight noises to a loss of vehicle control.
The problem was first noticed in December of last year by a GM test fleet driver and eventually tracked back to the improperly torqued bolts on the suspension cradle assembled through July 2012 by a supplier located not too far from the Malibu's Detroit/Hamtramck Assembly Plant. Since an official NHTSA recall notice has not been issued yet, it isn't clear whether or not Detroit-built Malibus were the only ones affected (the 2013 Malibu is also built at GM's Fairfax Assembly Plant in Kansas City, Kansas). Dealers will fix the problem by inspecting vehicles for proper torque specs, retightening if not within specs and, in some cases, perform a rear-wheel alignment.

C7 Corvette turbo with 1,000 horsepower promised from Hennessey

If you can't wait for the next-generation Chevrolet Corvette ZR1, Hennessey says they will have you covered. The Texas-based company has announced it will offer a spate of upgrades for the 2014 Corvette ranging from a range of bolt-on options all the way up to a 1,000-horsepower, twin-turbo system. Buyers can start with a cold air intake, cat-back exhaust or stainless steel long-tube headers, but Hennessey says it will also offer up three stages of forced induction mayhem should those bits and baubles not provide enough thrust.
Those choices start with a supercharger system good for up to 700 hp, though Hennessey will gladly ditch the blower in favor of two turbos. Doing so will spin the crank to the tune of 800 horsepower all the way up to a certifiably ludicrous 1,000 ponies. There's no word on how much these tricks will cost you - or when they will be available, as we're guessing they haven't gotten their hands on the car yet - but you can head over to the Hennessey site to drop them a line if you're curious.